ROTOR AS 7T2790 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 6V-3145 Load Leveling Beam 1
B 189-0409 Shackle As 2 Start By:
Remove the M.C.S panel for the control system and the support bracket. Refer to Disassembly and Assembly, "Control System - Remove and Install".
Remove the E.M.C.P panel for the control system and the support bracket. Refer to Disassembly and Assembly, "Control System - Remove and Install".
Remove the air cleaner housing. Refer to Disassembly and Assembly, "Air Cleaner Housing - Remove and Install".
The engine can have the ability to auto start. Ensure that the power supply is isolated before any service or repairs is performed.
Turn the air supply at the air reservoir to the OFF position. Ensure that the air pressure is drained from the starting air system.
Turn the battery disconnect switch to the OFF position.
Turn the fuel supply to the OFF position.
Illustration 1 g01722858
Disconnect harness assembly and cable assemblies (1) from electric starting motor (2). If the engine is equipped with a air starting motor disconnect the air supply. Ref to Disassembly and Assembly, "Air Starting Motor - Remove and Install" for more information
Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Drain" for the correct draining procedure.
For engines with a radiator cooling system, remove the radiator. Refer to Disassembly and Assembly, "Radiator - Remove and Install".
Remove the fan on a engine with a radiator cooling system. Refer to Disassembly and Assembly, "Fan - Remove and Install".
Illustration 2 g01723173
Illustration 3 g01724294
Turn the valve for the sea water circuit to the OFF position.
For a keel cooled engine and a sea water cooled engine, loosen the hose clamp and then disconnect hose (5) from the auxiliary water pump.
For a keel cooled engine, loosen hose clamp and disconnect hose (6) from the aftercooler.
For a keel cooled engine, loosen hose clamp and disconnect tube assembly (4) from the water temperature regulator housing. Loosen hose clamp and disconnect tube assembly (3) from the water pump inlet.
For a keel cooled engine, remove vent hose from the exhaust manifold.
Remove blanket (8) from the exhaust elbow and the exhaust outlet. Remove bolts and disconnect exhaust system (7) from the exhaust elbow.
Illustration 4 g01722859
MCS fuel system
Disconnect hose assembly (9) and hose assembly (10) from the secondary fuel filters. Disconnect hose assembly (14) (not shown). Note: Identify the position on the hose assembly in order to show the correct position of the hose assembly. Plug all hose assembly and cap all connections on the fuel filter base assembly.
Disconnect harness assembly (11) from the differential pressure switch for the primary fuel filters.
Disconnect harness assembly (12) from the differential pressure switch for the secondary fuel filters. Disconnect harness assembly (13) (not shown) from the fuel pressure sender.
Illustration 5 g01724333
Non-MCS fuel system
Disconnect hose assembly (14) from the primary fuel filter.
Illustration 6 g01724376
Loosen hose clamps (16) and remove breather hose (15) from