SAW GP 3599514 - Caterpillar

Disassembly
REMOVING ASTERN DRIVING GEAR AND REAR THRUST BEARING
1-Rear thrust bearing assembly. 2-Astern driving gear.1. Use a 1H3107 Push Puller, 1H3108 Puller Legs, 1H3110 Bearing Pulling Attachment, 7F9540 Hydraulic Puller, 9S5800 Hydraulic Pump Group and 5F9886 Adapter to pull rear thrust bearing assembly (1) and astern driving gear (2) off the astern driving shaft.2. Use a 1H3107 Push Puller, 1H3109 Puller Legs, 1H3110 Bearing Pulling Attachment, 7F9540 Hydraulic Puller and 9S5800 Hydraulic Pump to remove the bearing inner race (3) from the astern drive shaft.
REMOVING AHEAD DRIVE SHAFT ASSEMBLY
REMOVING BEARING INNER RACE FROM ASTERN DRIVE SHAFT
3-Inner race.
REMOVING DOUBLE TAPERED THRUST BEARING FROM AHEAD DRIVE SHAFT
4-Double tapered thrust bearing.3. Use a 1H3107 Push Puller, 1H3110 Bearing Pulling Attachment, 7F9540 Hydraulic Puller, 9S5800 Hydraulic Pump, and a 5F7694 Plug to remove double tapered thrust bearing (4) from the ahead drive shaft.4. Use a 1H3107 Push Puller with 1H3108 Puller Legs, 7F9540 Puller Attachment, 9S5800 Hydraulic Pump and a 5F7694 Plug to remove the ahead driving gear from the ahead drive shaft.
REMOVING AHEAD DRIVING GEAR
5-Outer race of front support bearing.
REMOVING FRONT SUPPORT BEARING FROM AHEAD DRIVE SHAFT
6-Front support bearing. 7-Inner race.5. Remove outer race (5).6. Use a 1H3107 Push Puller with 1H3108 Puller Legs, 7F9540 Hydraulic Puller, 9S5800 Hydraulic Pump, 1H3110 Bearing Pulling Attachment and a 5F7694 Plug to remove bearing (7) and inner race (6).
PREPARING TO REMOVE INNER BEARING FROM AHEAD DRIVE SHAFT
8-Retainer.
REMOVING INNER BEARING AND SHIELD
9-Bearing. 10-Shield.Main Shaft Assembly
Heat the bearing cones, gears and bearing inner race in oil, temperature not to exceed 240° F (115° C), to facilitate installation.1. Install front support bearing (6) on the ahead drive shaft. Place outer race (5) on bearing (6).2. Make certain the gear key is in the shaft and install the ahead driving gear, the spacer, and a bearing cup of thrust bearing (4). The smallest bore of the bearing cup is toward the ahead driving gear.3. Install a bearing cone of thrust bearing (4) with the small diameter toward the ahead driving gear. Install the other bearing cone with the large diameter against the large diameter of the first bearing cone.4. Place the cup spacer, the last bearing cup of thrust bearing (4) on the bearing cones and install the bearing