SCARIFIER GP 8X6080 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 5B-4274 Bolt 3
B 8T-0914(1) Guide Pin 2
(1) Part of 9U-5105 Engine Tool GroupStart By:
Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel and Ring Gear - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01294474Note: It is not necessary to remove adapter (4) in order to remove the crankshaft rear seal.
Remove bolts (2) that hold the crankshaft rear seal and adapter (1) in place.
Install Tooling (A) in adapter (1). Tighten Tooling (A) evenly. Remove the crankshaft rear seal and adapter (1) from the flywheel housing.
Install Tooling (B) through the holes in adapter (4).
Remove bolts (3) that hold adapter (4) in place.
Slide adapter (4) onto Tooling (B). Attach a suitable lifting device to adapter (4). The weight of adapter (4) is approximately 65 kg (143 lb). Remove adapter (4) from Tooling (B).