SCRAPER, REAR 03001676 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 185-3630 Strap Wrench As 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Drain the fuel filter into a suitable container for storage or disposal.
Illustration 1 g01368936
Disconnect hose assemblies (1). Disconnect harness assembly (2). Use Tooling (A) in order to remove fuel filter (3). Refer to Operation and Maintenance Manual, "Fuel System Primary Filter - Clean/Inspect/Replace".
Illustration 2 g01368940
Remove bolts (4) in order to remove filter base (5). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 185-3630 Strap Wrench As 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g01368940
Position filter base (5) and install bolts (4).
Illustration 4 g01368936
Use Tooling (A) in order to install fuel filter (3). Refer to Operation and Maintenance Manual, "Fuel System Primary Filter - Clean/Inspect/Replace". Connect harness assembly (2). Connect hose assemblies (1).