SCRAPER 2114674 - Caterpillar

Before performing any operation or maintenance procedures, ensure that the safety information, warnings, and instructions are read and understood. Failure to adhere to proper maintenance intervals may result in the degradation of the engine's performance and/or the accelerated wear of the engine's components.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must be performed.When Required
Batteries - Replace
Engine Air Cleaner Element - Replace
Engine Oil Filter - Change
Overhaul Considerations
Valve Stem Projection - Measure/Record
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Control Panel - Inspect
Cooling System Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Clean
Engine Oil Level - Check
Fuel System Fuel Filter Differential Pressure - Check
Jacket Water Heater - Check
Walk-Around Inspection
Every Week
Battery Charger - Check
Electrical Connections - Check
Initial 250 Service Hours
Valve Stem Projection - Measure/Record
Every 250 Service Hours
Battery Electrolyte Level - Check
Engine Oil Sample - Obtain
Initial 1000 Service Hours
Cooling System Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Mounts - Check
Engine Speed/Timing Sensor - Clean/Inspect
Valve Stem Projection - Measure/Record
Every 1000 Service Hours
Belts - Inspect/Adjust/Replace
Carburetor Air/Fuel Ratio - Check/Adjust
Crankshaft Vibration Damper - Inspect
Engine Crankcase Breather - Clean
Engine Oil - Change
Engine Oil Filter (Auxiliary) - Change
Engine Oil Filter - Change
Exhaust Piping - Inspect
Gas Pressure Regulator Condensation - Drain
Hoses and Clamps - Inspect/Replace
Ignition System Spark Plugs - Inspect/Replace
Ignition System Timing - Check/Adjust
Inlet Air System - Inspect
Radiator - Clean
Every 2000 Service Hours
Actuator Control Linkage - Lubricate
Cooling System Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Inspect/Adjust
Every 4000 Service Hours
Air Starting Motor Lubricator Bowl - Clean
Alternator - Inspect
Crankcase Blowby - Measure/Record
Cylinder Pressure - Measure/Record
Engine Mounts - Check
Engine Protective Devices - Check
Exhaust Bypass - Inspect
Starting Motor - Inspect
Water Pump - Inspect
Every 8000 Service Hours
Cooling System Coolant Sample (Lev