SCRAPER-ROD 4738596 - Caterpillar

1. Remove screws (2) and angle (cover) (1) from the cab door. 2. Remove the cotter pin and washer (2) from the handle assembly. 3. Remove screws (3), handle assembly (4) and the gasket from the cab door. 4. Remove screws (5) and latch (6) from the cab door. 5. Remove the cotter pin, washer (7), rod (8) and the spring washer from the latch. 6. Remove the cotter pin, washer (10), rod (8) and the spring washer from arm (9). 7. Remove bolts (11), disconnect switch (14) and remove catch (12) from the cab.8. If necessary disconnect wires (13) and remove switch (14) from the cab.Install Door Latch And Catch
1. Install spring washer (2) on arm (1) so that the outside surface of the washer is against the arm. Install rod (5), washer (3) and cotter pin (4) on arm (1). 2. Install spring washer (7) on latch (6) so the outside surface of the washer is against the latch. Install rod (5), washer (8) and cotter pin (9) on latch (6). 3. Install latch (6) on the cab door. 4. Install gasket (8) and handle assembly (7) on the cab door. 5. Connect arm (1) to the handle assembly and install washer (9) and the cotter pin on the handle assembly. 6. Put angle (11) in position on the cab door with screws (10) that hold it. 7. Install wires (14) on switch (15).8. Install catch (13) and switch (15) on the cab.9. If necessary, loosen bolts (12) and make an adjustment to the catch and switch for the correct latch and door contact.