SCREEN GP-HYDRAULIC 1076418 - Caterpillar

Illustration 5 g02719603
Remove the three 138-4854 Screws from the bottom of the cover. Refer to Illustration 5.
Illustration 6 g02719604
Two tabs connect the right and left-hand side covers. In order to remove the 302-8247 Cover without damaging the tabs, push down on the right hand cover and pull the covers apart. Refer to Illustration 6
Illustration 7 g02719605
Pop the 369-1863 Cable As out of the slot and remove the cable from the 369-1864 Clip with a flat head screwdriver. Be careful not to break the clip. Refer to Illustration 7
Remove existing cable assembly from console.
Inspect the 369-1864 Clip for damage. If clip is broken, replace the 369-1864 Clip .
Illustration 8 g02719606
Route new 369-1963 Cable As through back of console. Refer to Illustration 8
Illustration 9 g02719608
Illustration 10 g02719609
Incorrect routing of the 369-1963 Cable As .
Illustration 11 g02719610
Correct routing of the 369-1963 Cable As .
Install the new 369-1963 Cable As into the clip. Refer to Illustration 9Note: Incorrect routing of the 369-1963 Cable As can result in damage to the cable and improper functioning of the armrest release/locking functionality.
Illustration 12 g02719612
At the front of the steering console, route the 369-1863 Cable As between the joystick and the bracket. Refer to Illustration 12. Do not route the 369-1863 Cable As between the cover and the outside of the bracket. Refer to Illustration 10.
Illustration 13 g02719614
Reinstall the right hand 285-7989 Cover . Refer to Illustration 13. Make sure to pull the 369-1863 Cable As through the hole. The cable assembly should sit freely along the top of the left-hand steering console. Install three 9X-2043 Screws . Tighten the three 9X-2043 Screws on the 302-8247 Cover . Install the three 138-4554 Screws on the bottom of the covers.
Illustration 14 g02719615
Insert and secure the die cast barrel of the 369-1863 Cable As into lever assembly. Slide the die cast barrel fully into the round slot of the cable catch on the lever. Refer to Illustration 14
Illustration 15 g02719617
Pull up on the release lever and snap the snub end coupling on the cable assembly into the center (middle) slot on the lever assembly. If properly assembled, the cable should not contact the lever assembly when the lever is activated. Refer to Illustration 15Note: Do not kink the cable during installation.
Install the 367-5533 Lever As , and secure with two 137-6723 Screws .
Ensure the armrest releases and locks properly.
Reassemble the remaining covers and components using the saved hardware.