SCREEN GP 1117376 - Caterpillar

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Operate the machine for a few minutes in order to warm the hydraulic system oil.Park the machine on level ground. Lower the bucket to the ground and apply slight downward pressure. Engage the parking brake and stop the engine.
Illustration 1 g00945823
Relieve the hydraulic tank pressure by pushing on top of breaker relief valve (1) before removing the oil filler cap.
Illustration 2 g00945824
Remove oil filler cap (2) slowly to relieve any remaining pressure.
Illustration 3 g00945825
Note: Hand tighten the NPT pipe nipple. Do not use tools.
Remove hydraulic tank drain plug (3). Install a 1 inch NPT pipe nipple, 88 mm (3.50 inch) long, in the bottom of the tank, to open the internal drain valve. Drain the oil into a suitable container.
Remove the pipe nipple. Clean the drain plug and install the drain plug.
Change the hydraulic system oil filters.Reference: For the correct procedure, refer to the Operation and Maintenance Manual, "Hydraulic System Oil Filter - Replace" for the machine that is being serviced.
Remove the strainer retaining ring. Remove the strainer from the hydraulic oil filler tube.
Wash the oil filler cap and the strainer in clean, nonflammable solvent. Allow the oil filler cap and the strainer to dry.
Inspect the oil filler cap gasket. Use a new gasket if the used gasket is damaged. Install the strainer and the retaining ring in the filler tube.
Fill the hydraulic tank with clean oil. Make sure that the oil level is at the "FULL" mark on the sight gauge. Install the filler cap.Reference: For information on lubricants and refill capacities, refer to the Operation and Maintenance Manual, "Lubricant Viscosities and Refill Capacities" for the machine that is being serviced.
Start the engine and run the engine at low idle. Check for leaks.
Illustration 4 g00928136
Maintain the oil level above the "ADD COLD" mark in sight gauge (4). Add more oil, if necessary through filler tube (5) .Note: The oil must be free of bubbles. If bubbles are present in the oil, air is entering the hydraulic system. Inspect the hydraulic suction line hoses and the hose clamps.
Stop the engine.
If necessary, tighten any loose clamps or any loose connections. Replace any damaged hoses.