SCREEN AS 1838104 - Caterpillar

Illustration 7 g01314488
Click "OK" again.
Enter the factory passwords. Then, click "OK".
Illustration 8 g01314489
AccuGrade is installed. Note: If you are going to enable AccuGrade, ignore this Step 8 and continue to Step 9.
Cycle the key in order for the other electronic control modules to recognize AccuGrade.
After AccuGrade is installed, the user can enable the system.
Illustration 9 g01314490
Double click "AccuGrade Enable Status".
Illustration 10 g01314491
Select "Enable" and then click "OK".
Illustration 11 g01314492
Click on "Yes".
Illustration 12 g01314493
"AccuGrade Enable Status" is enabled.
Cycle the key. Software Enable Attachment (Temporary Installation) Procedure For M Series Motor Graders
Connect to ET.
Click on "Service/Configuration".
Illustration 13 g01460739
Double click "Accugrade Temporary Installation Status". Select "Installed".
Illustration 14 g01460750
The "AccuGrade Temporary Installation Status" is now installed.
Illustration 15 g01460751Note: The "AccuGrade Temporary Installation Status" will remain installed for 50 hours. After the 50 hour time period expires the system will revert to a uninstalled state.
Cycle the key for the machine start switch. Configuring the Implement/Valve Control ECM
The Implement/Valve Control ECM is shipped from the factory with the status of the AccuGrade System in the "Not Installed" state. Configure the Implement/Valve Control ECM to the "Installed" state before using the system. Use the following procedure in order to configure the Implement/Valve Control ECM.Procedure
Connect the 7X-1425 Data Link Cable Assembly between the 7X-1700 Communication Adapter Group and the Electronic Technician.
Connect the 139-4166 Data Link Cable Assembly between the 7X-1700 Communication Adapter Group and the diagnostic connector of the machine.
Turn the key start switch to the "ON" position.
Open up the Electronic Technician software and select the "Grade/Slope Control".
Illustration 16 g01181296
Select the "Configuration" option in the "Service Menu".
Illustration 17 g01181331
Double click on the "Accugrade System Installation Status" parameter.
Illustration 18 g01181333
Change the new value to "Installed" and click the "OK" button.
Illustration 19 g01181336
Click on the "Yes" button.
Verify that the correct sales model is selected. If the selected sales model is incorrect, repeat this procedure for the "Product Sales Model" parameter.