SCREEN- 4176203 - Caterpillar

Illustration 9 g01708053Engine Interface Connector (40 Pin)
Illustration 10 g01708216Connector for the Interconnect Harness to the Remote Panel
Illustration 11 g01707358Harness Connectors
Harness Connector for the Fuel Metering Valve
Illustration 12 g01709615Harness Connector at the Compressor Bypass Actuator
Illustration 13 g01708615Harness Connector at the Throttle Actuator
Illustration 14 g01411816Harness Connector at the Exhaust Temperature Scanner
Illustration 15 g01710436Sensor Connectors
Analog Sensor Connector (Active Sensors)
Illustration 16 g01159881Analog Sensor Connector (Passive Sensors)
Illustration 17 g01436505Sensor Connectors for PWM Sensors
Illustration 18 g01414254
Illustration 19 g01240891Connections to the Terminal Strip at the Remote Panel
Illustration 20 g01783015
Terminal strip at the remote panel
(Terminal 4) +Battery
(Terminal 6) Analog sensor supply
(Terminal 7) Desired speed (speed potentiometer)
(Terminal 8) Return
(Terminal 9) Shield
(Terminal 13) Cat Data Link +
(Terminal 14) Cat Data Link −
(Terminal 15) Digital return from the engine control switch to the ECM
(Terminal 16) Signal for start mode from the engine control switch to the ECM
(Terminal 17) Driven equipment
(Terminal 18) Keyswitch circuit
(Terminal 19) Normal stop switch
(Terminal 20) Alarm active
(Terminal 22) Idle/rated speed switch
(Terminal 23) Return
(Terminal 24) Signal for auto mode from the engine control switch to the ECM
(Terminal 25) Engine failure
(Terminal 26) Manual prelube switch
(Terminal 27) Crank terminate
(Terminal 28) Emergency stop
(Terminal 29) Run relay
(Terminal 30) Power for the gas shutoff valve
(Terminal 31) Signal for stop mode from the engine control switch to the ECM
(Terminal 32) Timing switch (No 2)
(Terminal 33) Prelube light
(Terminal 35) CAN data link +
(Terminal 36) CAN data link −
(Terminal 37) Return for the gas shutoff valve
(Terminal 38) CAN data link (shield)
(Terminal 39) Keyswitch
(Terminal 40) -Battery