AVSPARE.COM
parts catalog

SCREEN AS 4Z8907 - Caterpillar



4Z8907 SCREEN AS Caterpillar parts D6R, D6R II SCREEN
Rating:
9
Alternative (cross code) number:
CA4Z8907
4Z-8907
4Z8907
Caterpillar 4Z8907 SCREEN AS

Buy SCREEN AS 4Z8907 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK-TYPE TRACTOR,

Compatible equipment models: 4Z8907:

TRACK-TYPE TRACTOR  D6R   D6R II   Caterpillar
Number on catalog scheme: 3
 
  For full view, you need register

Information:

Test Procedure
System Operation
The SLC 5/04 diagnostic indicators are located on the front of the following components: Power Supply, CPU and I/O Modules.The diagnostic indicators help trace the source of the fault. Faults can be found in the following components: Input devices, Output devices, Wiring and The controller.When the red LED is illuminated, there is a fatal error. A fatal error indicates that the processor is not communicating.
Illustration 1 g00563543
Diagram of the LED indicators
Illustration 2 g00562937
Functional Test
Check the electrical connectors and check the wiring.
Bodily contact with electrical potential can cause bodily injury or death.To avoid the possibility of injury or death, ensure that the main power supply has been disconnected before performing any maintenance or removing any modules.
Disconnect the power supply.
Check the electrical connectors and check the wiring for damage or bad connections.
Verify that all modules are properly seated.
Verify the status of the LED on the SLC 5/04.The results of the preceding procedure are in the following list:
All of the components are fully installed. All of the components are free of corrosion. All of the components are free of damage. All of the modules are properly seated. Proceed to 4.
The components are not fully installed. The components are not free of corrosion. The components are damaged. All of the modules are not properly seated. Repair the component. Verify that the repair resolves the problem. STOP.
Cycle the power.
Secure power to the PLC.
Energize the PLC.The results of the preceding procedure are in the following list:
No errors are displayed on the LED indicators. Stop.
Errors are displayed on the LED indicators. Proceed to 3.
Test the memory module.
To avoid damage to electronic components, do not remove the processor from the SLC 5/04 Chassis until all power is removed from the power supply.Do not expose memory modules to surfaces or areas that may typically hold an electrostatic charge.
Bodily contact with electrical potential can cause bodily injury or death.To avoid the possibility of injury or death, ensure that the main power supply has been disconnected before performing any maintenance or removing any modules.
Disconnect the power supply.
Remove the processor from the chassis.
Remove the memory module.
Install the processor.
Connect the power supply.
Energize the PLC.Reference: Maintenance Procedure, "Memory Module - Replace"The results of the preceding procedure are in the following list:
The "FLT" LED is flashing. Replace the memory module. Refer to Maintenance Procedure, "Memory Module - Replace". Stop.
The "FLT" LED is steady. Install the memory module. Proceed to 4.
Check the line voltage.
Reconnect the power supply.
Measure the line voltage at the terminals.
Verify the voltage of the power supply. The power supply voltage should be measured between 21.0 VDC and 28.0 VDC.The results of the preceding procedure are in the following list:
The line voltage is in the range. Install the processor in another chassis. Verify the diagnostic indicators. The fault is present. Replace the processor. Verify that the repair solves the problem. Refer to Maintenance Procedure, "Processor - Replace".
The line voltage is out of the range. Refer to Troubleshooting, "System Power". Stop.

Caterpillar parts catalog:

Caterpillar parts catalog
D6R Custom Parts Manual Track-Type Tractors 1RW00001-UP (MACHINE) POWERED BY 3306 Engine
D6R SERIES II CUSTOM PARTS MANUAL TRACK-TYPE TRACTOR AAX00001-UP (MACHINE) POWERED BY C-9 Engine


Parts screen Caterpillar catalog:

8S9130 SCREEN-SUCTION
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M 2, 14...
4S8598 SCREEN-SUCTION
14G, 14H, 14H NA, 16G, 16H, 16H NA, 24H, 24M, 3192, 515, 525, 525B, 525C, 525D, 535B, 535C, 535D, 545, 545C, 545D, 555D, 572R, 572R II, 578, 583R, 587R, 587T, 611, 613C, 613C II, 613G, 615, 615C, 65, ...
3T6471 SCREEN AS
365C, 365C L, 365C L MH, 374D L, 374F L, 375, 375 L, 385B, 385C, 385C FS, 385C L, 385C L MH, 390D, 390D L, 390F L, 5080, 5090B, 527, 561M, 561N, 572R, 572R II, 578, 583R, 583T, 587R, 587T, 613G, C18, ...
1662153 SCREEN AS
D6R, D6R II, D6R III, D6T, D7R II
1652577 SCREEN AS
D6R, D6R II, D6R III, D6T, D7R II, D8R, D8R II
1095498 SCREEN AS
D6R, D6R II, D6R III, D6R STD, D6T, D7R, D7R II, D7R XR, D9R
1058096 SCREEN
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 315B FM L, 320B FM LL, 320C FM, 322B L, 322C, 322C FM, 325B L, 325C FM, 330B L, 330C FM, 345C, 511, 521, 521B, 522, 522B, 532, 541, 541 2,...
5Q6782 SCREEN AS
963B, 963C, 973, 973C
2264909 SCREEN
824K, 825K, 826G II, 826H, 834G, 834H, 836G, 836H, 938H, 988G, 988H, D10N, D10R, D10T, D10T2, D6G2 LGP, D6G2 XL, D6R, D6R II, D6R III, D6T, D6T LGP, D6T LGPPAT, D7R II, D8N, D8R, D8R II, D8T, D9R, D9T...
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.