SCREW 0813962 - Caterpillar

Drill pattern template for the 353-4515 Toggle Switch Gp (radio disable switch).
Mount the 353-4515 Toggle Switch Gp (radio disable switch) in a convenient location. Place the 433-9723 Film near the switch.
Plug the 353-4515 Toggle Switch Gp into the 174-0502 Connector Plug As that came installed on the harness or was installed on the harness in the previous steps. If the 174-0502 Connector Plug As does not reach the 353-4515 Toggle Switch Gp, continue to Step 8.a to create a jumper harness.
Determine the distance needed between the harness and the 353-4515 Toggle Switch Gp. Get two lengths of electrical wire at the distance needed. Install one 9X-3402 Connector Socket and one 3E-3390 Connector Pin on the end of each wire.
Install the wires with the 9X-3402 Connector Socket into positions "B" and "C" in one 174-0502 Connector Plug As.
Install the wires with the 3E-3390 Connector Pin into positions "B" and "C" in one 102-8803 Receptacle Kit.
Route and plug the newly created jumper harness into the 353-4515 Toggle Switch Gp and three-pin radio disable switch connectors on the harness.
Install the 6T-6969 Switch Guard over the switch.
Place the main disconnect switch in the ON position.
Turn the key switch to the ON position.
Verify that the radio is ON.
Move the Radio Disable switch to the OFF position.
Verify that the radio is OFF.
Return the Radio Disable switch to the ON position.Operation
To use the radio disable switch, perform the following steps:
Raise the Switch Guard.
Place the switch in the OFF position.
Return the switch to the ON position when conditions are appropriate.
Lower the Switch Guard to protect the switch.Device Replacement, Device Swap, and Device Upgrade for the PL641 Systems
PL641 Cellular Radio Replacement
Note: When a radio is replaced on a "Pro" installation, the device will become unsubscribed and must be subscribed again in the "Dealer Services Portal".
Set the Product ID on the radio back to default value of "CAT00000". Refer to Special Instruction, REHS9111, "Set the Product ID on the Product Link Device".
Wait some time for the radio to send off the registration info and break the link between this device and the truck in the back-office.Note: Removing and reusing the first radio from the equipment without resetting the Product ID can potentially cancel the subscription from the original piece of equipment the radio was installed on.
Remove the radio from the system (first radio).
Install the new radio (second radio).
Set the Product ID on the radio to the Prime Product serial number. Refer to Special Instruction, REHS9111, "Set the Product ID on the Product Link Device".
Set the subscription to the equipment in the "Dealer Services Portal".Pro System Device Swap
A device swap is when a Product Link system is removed from one piece of equipment and installed on another piece of equipment.
Cancel services on the truck that the radio is installed on.
Set the Product ID on the radio back to default value of "CAT00000". Refer to Special Instruction, REHS9111, "Set the Product ID on the Product Link Device".
Install the Product Link System onto the second