SCREW 1144323 - Caterpillar

Specifications
Illustration 1 g02350896
Table 1
SPECIFICATIONS FOR 337-2181 Flywheel    
Callout     Part Number     Part Name     Specification Description    
3     9X-2053     Bolt     Apply 9S-3263 Thread Lock Compound to the threads.
Torque to.........................
300 40 N m (221 30 lb ft)    Removal Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     -     Guide Bolt
(M16 x 2 by 4 inch)     2    
B     138-7573     Link Bracket     1    
C     9S-3263     Thread Lock Compound     1    Start By:
Remove the torque converter.
Illustration 2 g02350849
Engine is photographed out of chassis for photographic purposes.
Remove retaining ring (1) and remove sun gear (2) .
Illustration 3 g02350858
Remove top bolt (3). Install Tooling (A). Remove remaining bolts (3) .
Fasten Tooling (B) and a suitable lifting device to flywheel (4). The weight of flywheel (4) is approximately 40 kg (85 lb).Note: If your engine is equipped with a Rear Power Take-Off RPTO, you will need to keep Tooling (A) installed. Tooling (A) will hold the crankshaft gear in place during the removal of the flywheel.
Remove flywheel (4) .
Use a hammer and a punch in order to remove the flywheel ring gear, if necessary.Installation Procedure
Install flywheel (4) in the reverse order of removal.
Raise the temperature of the flywheel ring gear. Do not use a torch to heat the flywheel ring gear. Install the flywheel ring gear on the flywheel. Position the flywheel ring gear with the part number toward the crankshaft. Allow the flywheel ring gear to cool. Use a soft hammer in order to seat the flywheel ring gear against the shoulder of the flywheel.
Apply Tooling (C) to the threads of bolts (3)
Tighten bolts (3) evenly to a torque of 300 40 N m (221 30 lb ft).
Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect".