SCREW-CAP 2097279 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Accidental engine starting can cause injury or death to personnel working on the equipment.To avoid accidental engine starting, disconnect the battery cable from the negative (−) battery terminal. Completely tape all metal surfaces of the disconnected battery cable end in order to prevent contact with other metal surfaces which could activate the engine electrical system.Place a Do Not Operate tag at the Start/Stop switch location to inform personnel that the equipment is being worked on.
Disconnect the batteries.
Put an index mark on all of the harness assemblies that are connected to the electric starting motor and the solenoid.
Illustration 1 g01100842
Disconnect the harness assemblies from solenoid (1).
Disconnect harness assembly (2).
Fasten a suitable lifting device to electric starting motor (3). The weight of the electric starting motor is approximately 26 kg (57 lb).
Remove bolts (4). Remove electric starting motor (3) and gasket (5) from the flywheel housing. Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01100842
Fasten a suitable lifting device to electric starting motor (3). The weight of electric starting motor is approximately 26 kg (57 lb).
Position electric starting motor (3) and gasket (5) on the flywheel housing. Install bolts (4). Remove the lifting device from the electric starting motor.
Position the harness assembly on the electric starting motor and install nut (2). Tighten the nut to a torque of 31 4 N m (23 3 lb ft).
Illustration 3 g01100656
Position the harness assembly on the solenoid and install nut (8). Tighten the nut to a torque of 31 4 N m (23 3 lb ft).
Position the harness assembly on the solenoid and install nut (8). Tighten the nut to a torque of 2.25 0.25 N m (20 2 lb in).
Position the harness assembly to the solenoid and install nut (7). Tighten the nut to a torque of 2.25 0.25 N m (20 2 lb in).
If necessary, install the connector and install nut (10) and bolt (9). Tighten the nut and the bolt to a torque of 31 4 N m (23 3 lb ft).
Connect the batteries.