2256478 SCREW-MACHINE Caterpillar parts
3054C, 3054E, 312D2, 312D2 GC, 312D2 L, 313D2, 313D2 LGP, 315C, 318D2 L, 414E, 416D, 416E, 416F, 420D, 420E, 420F, 422E, 422F, 424D, 428D, 428E, 428F, 430D, 430E, 430F, 432D, 432E, 432F, 434E, 434F, 4...
Rating:
Alternative (cross code) number:
CA2256478
225-6478
2256478
CA2256478
225-6478
2256478
Weight: 0.01 pounds 0 kg.
ASPHALT PAVER, WHEELED EXCAVATOR,
This part in 2 request:
Show.
This information for suppliers only!
2019-01-15
2019-01-11
Compatible equipment models: 2256478:
Number on catalog scheme:
2
For full view, you need register
Information:
Sliding window glass assemblies (groups) are removed and installed with same procedure.
If it is necessary to remove damaged glass, use thick gloves to avoid injury.
1. Put tool (A) in between the two lips of seal (1) as shown. Move tool (A) along the seal to pull the locking lip out away from the cab. Move the tool completely around the circumference of the glass.
TYPICAL EXAMPLE2. With locking lip out, remove the glass from the opening. Remove seal (1) from the edge of the window opening.Install Cab Window Glass
Handle glass carefully.
TYPICAL EXAMPLE1. Start along the side of the window panel opening to install seal (3). Install edge (4) of seal over panel (5) with the locking lip toward the outside of the cab. When the glass is installed, edge (2) must be over glass (1) as shown.
TYPICAL EXAMPLE2. Install the seal around the circumference of the window opening. Cut the seal to extend past the starting point by .125 in. (3.18 mm) per foot of window opening circumference. Push the ends of the seal together and push them over the body panel to make a tight, smooth joint.3. Put the lower corner of the glass in the channel of the seal as far as possible. Do not use too much force.4. Move in both directions from the starting point, lift the glass channel lip and the glass will slip into place. 5. Put a solution of soap and water on the locking lip of the seal. 6. Install the curved end of tool (A) or (7) between locking lip (6) and its groove (8) at any point away from the seal joint.7. Move the tool along groove (8) as shown.8. Move tool (A) completely around the circumference of seal, the rubber lip will lock into position around the circumference of the glass.
If it is necessary to remove damaged glass, use thick gloves to avoid injury.
1. Put tool (A) in between the two lips of seal (1) as shown. Move tool (A) along the seal to pull the locking lip out away from the cab. Move the tool completely around the circumference of the glass.
TYPICAL EXAMPLE2. With locking lip out, remove the glass from the opening. Remove seal (1) from the edge of the window opening.Install Cab Window Glass
Handle glass carefully.
TYPICAL EXAMPLE1. Start along the side of the window panel opening to install seal (3). Install edge (4) of seal over panel (5) with the locking lip toward the outside of the cab. When the glass is installed, edge (2) must be over glass (1) as shown.
TYPICAL EXAMPLE2. Install the seal around the circumference of the window opening. Cut the seal to extend past the starting point by .125 in. (3.18 mm) per foot of window opening circumference. Push the ends of the seal together and push them over the body panel to make a tight, smooth joint.3. Put the lower corner of the glass in the channel of the seal as far as possible. Do not use too much force.4. Move in both directions from the starting point, lift the glass channel lip and the glass will slip into place. 5. Put a solution of soap and water on the locking lip of the seal. 6. Install the curved end of tool (A) or (7) between locking lip (6) and its groove (8) at any point away from the seal joint.7. Move the tool along groove (8) as shown.8. Move tool (A) completely around the circumference of seal, the rubber lip will lock into position around the circumference of the glass.
Cat SIS web machinery list:
Parts screw Caterpillar catalog:
307, 311B, 312, 312B L, 315, 315B L, 317, 317B LN, 318B, 320B, 322B LN, 325 L, 325B L, 330 L, 330B L, 345B II, 345B L, 350, 365B, 365B II, 375, 385B, 5080, 5090B, CB-434D, CB-534D, CB-564D
24M, 311C, 311D LRR, 312C, 312C L, 312D, 312D L, 314C, 315C, 315D L, 318C, 319C, 319D L, 319D LN, 320 L, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D LN, 321C, 322C, 322C FM, 323D L, 323D LN...
120H, 12H, 135H, 140H, 143H, 14H, 160H, 163H, 16H, 550B, 560B, 570B, 580B, 953C, 963C, 973C, M312, M313C, M315, M315C, M316C, M318, M318C, M318C MH, M320, M322C
120M, 120M 2, 12M, 12M 2, 12M 3, 12M 3 AWD, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160M, 160M 2, 160M 3, 160M 3 AWD, 16M, 24H, 24M, 350, 375 L, 5080, 515, 525, 525B, 525C, 535B, 535C, 545, 545C, 621F,...
2384C, 2484C, 311B, 311C, 311D LRR, 311F LRR, 312B L, 312C, 312C L, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315B L, 315C, 317B LN, 318B, 318C, 319C, 320B, 320B L, 320C, 320C FM, 320C L, 320D, 320D...
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304C CR, 304D CR, 304E, 305.5D, 305.5E, 305C CR, 305D CR, 305E, 307C, 307D, 307E, 308C, 308D, 30...
307C, 307D, 311C, 311D LRR, 311F LRR, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 315C, 315D L, 316E L, 318C, 318D L, 318D2 L, 318E L, 319D L, 319D LN, 320C, ...
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 330C, 330C FM, 330C L, 330C MH, 345B II, 345B II MH, 511, 521, 521B, 522, 522B, 532, 541, 541 2, 551, 552, 552 2, 583T, 631E, 631G, 637E, ...
320B, 793D, 793F, 793F CMD, 793F OEM, 793F-XQ, 914G, 924K, 930K, 933C, 938K, D3C III, IT14G, IT14G2, M315D, M316D, M317D 2, M318D, M318D MH, M322D, M322D MH, M325D L MH, M325D MH, M330D, PL61
120G, 120H, 120H ES, 120H NA, 12G, 12H, 12H ES, 12H NA, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 16G, 16H NA, 215, 225, 227, 229D, 2...
16M, 24H, 320C FM, 320D, 320D FM, 322C, 322C FM, 324D FM, 324D FM LL, 325C FM, 325D FM, 330C FM, 330D FM, 375, 375 L, 5130, 5130B, 515, 5230, 5230B, 525, 525B, 533, 535B, 543, 545, 572R, 621G, 623G, 6...
120M, 120M 2, 12M, 12M 2, 12M 3, 12M 3 AWD, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160M, 160M 2, 160M 3, 160M 3 AWD, 16M, 2470C, 2570C, 2670C, 2864C, 515, 518, 518C, 525, 525B, 525C, 525D, 533, 535B, ...
2097227
SCREW AS
TL5 30
TL5 30
2040128
SCREW
TL4 24
TL4 24
2129710
SCREW AS-ADJUSTMENT
TL4 24
TL4 24
8C6431
SCREW-FLAT HEAD
205, 205B, 206, 206B, 211B, 212, 212B, 213B, 214B, 224B, 416E, 422E, 422F, 428E, 428F, 432E, 432F, 434E, 434F, 442E, 444E, 444F, TH215
205, 205B, 206, 206B, 211B, 212, 212B, 213B, 214B, 224B, 416E, 422E, 422F, 428E, 428F, 432E, 432F, 434E, 434F, 442E, 444E, 444F, TH215
2307120
SCREW
TH210, TH215
TH210, TH215
120M, 12M, 140M, 140M 2, 14M, 160M, 160M 2, 16M, 205, 206, 212, 213B, 214B, 224B, 550, 550B, 560B, 570, 570B, 580, 580B, 950H, 953D, 962H, 963D, 966H, 972H, 973D, 986H, CB-214B, CB-224C, CB-44B, CB-54...
7Y5287
SCREW-TRUSS HEAD
307B, 307C, 307D, 308D, 311B, 311C, 320B, 325, 325B, 345C, TH220B, TH330B, TH340B, TH350B, TH355B, TH460B, TH560B, TH580B
307B, 307C, 307D, 308D, 311B, 311C, 320B, 325, 325B, 345C, TH220B, TH330B, TH340B, TH350B, TH355B, TH460B, TH560B, TH580B
TH220B, TH330B, TH340B, TH350B, TH355B, TH460B, TH560B, TH580B
TH220B, TH330B, TH340B, TH350B, TH355B, TH460B, TH560B, TH580B
1967691
SCREW
3054, 3056, AP-1055D, AP-655C, BG-260D, C4.4, TH220B, TH330B, TH340B, TH350B, TH355B, TH460B, TH560B, TH580B
3054, 3056, AP-1055D, AP-655C, BG-260D, C4.4, TH220B, TH330B, TH340B, TH350B, TH355B, TH460B, TH560B, TH580B
120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 135H, 135H NA, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 143H,...
0443994
SCREW
245, 3406, 3406B, 3408, 3412, 3508, 3512, 3516, 589, 631E, 637E, 651E, 657E, 773B, 834B, 988B, 992C, D10, G3406, G3408, G3412, G3512, G3516, TH220B, TH330B, TH340B, TH350B, TH355B, TH460B, TH560B, TH5...
245, 3406, 3406B, 3408, 3412, 3508, 3512, 3516, 589, 631E, 637E, 651E, 657E, 773B, 834B, 988B, 992C, D10, G3406, G3408, G3412, G3512, G3516, TH220B, TH330B, TH340B, TH350B, TH355B, TH460B, TH560B, TH5...