SCREW-MACHINE 2N3480 - Caterpillar

Electronic Modular Control Panel (EMCP3)
Illustration 1 g01527163
EMCP3 Control Panel
(1) Display Screen
(2) Yellow Warning Lamp
(3) Red Shutdown Lamp
(4) Alarm Acknowledge/Silence key
(5) Lamp Test key
(6) Stop key
(7) Auto key
(8) "Run key"
(9) Escape key
(10) Enter key
(11) Up key
(12) Right key
(13) Down key
(14) Left key
(15) Horn
(16) Emergency Stop Push Button
(17) Engine Overview key
(18) "AC Overview key"
(19) Side view of panel
(20) External Connection of an Alarm
(21) AC Connector
(22) Isolator Keyswitch Power for the panel is supplied by the Isolator keyswitch (22).The EMC panel is operated by keys on the control panel. The keys (2), (3) and (4) are acknowledge keys for an alarm and for shutdown. The keys (9), (7) and (8) are controlling keys. The keys control starting auto starting and the stopping of the genset. The keys (9), (10), (11), (12), (13), (14), (17) and (18) are navigation keys.Display Area (1) - The display area shows information about the generator set.Yellow Warning Lamp (2) - This lamp can flash or this lamp can stay illuminated. A flashing lamp indicates that there is a warning. A illuminated lamp indicates that a warning has been acknowledged. In order to verify the warnings, press the Alarm Acknowledge/Silence key (4). If there are no longer any active warnings, then the lamp will turn off. If active warnings still exist, then the lamp will change from a flashing lamp to an illuminated lamp.Red Shutdown Lamp (3) - This lamp can flash or this lamp can stay illuminated. A flashing lamp indicates that a shutdown event has occurred. A illuminated lamp indicates that the shutdown event has been acknowledged. In order to verify the shutdown event, press the Alarm Acknowledge/Silence key (4). If there are no longer any active shutdown event, then the lamp will turn off. If active shutdown event still exist, then the lamp will change from a flashing lamp to an illuminated lamp. Any condition that has caused a shutdown event must be manually reset.Alarm Acknowledge/Silence key (4) - In order to stop the horn, press the Alarm Acknowledge/Silence key. If the horn is operated, one or both of the alarm lamps (2) or (3) will begin to flash. Operation of the key can have two different functions. This Depends on the status of the alarms. Operation of the key will turn off the lamp or the lamp will stay illuminated . A global acknowledgment signal will be sent .Lamp Test key (5) - Pressing the lamp test key and holding the lamp test key will cause all of the LED indicators and the display screen pixels to illuminate. The LED indicators and the display screen pixels will remain illuminated until the key is released.Stop key (6) - Pressing the "STOP" key causes the EMCP 3 to enter the "STOP" mode. The stop lamp will become illuminated.Auto key (7) - Pressing the "AUTO" key causes the EMCP 3 to enter the "AUTO" mode. When the panel is in "AUTO" mode the "AUTO" light will become illuminated. The engine can now be started from a remote