SCREW-MACHINE 3E4316 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-7638 Magnetic Holding Tool 18
B 201-4211 Camshaft Pilot 1
201-4212 Camshaft Pilot 1
Illustration 1 g01292428
Install Tooling (B). Note: Ensure that camshaft (6) and Tooling (B) are clean. Apply clean engine oil to the lobes and journals of camshaft (6) and Tooling (B).Note: During installation of camshaft (6), rotate the camshaft in both directions in order to prevent binding in the camshaft bearing bores.
Carefully install camshaft (6) in the engine.
When installing the camshaft, make sure the number one cylinder is at top center of the compression stroke with the timing bolt installed in the flywheel. The camshaft timing is very important. The timing mark on the camshaft drive gear must line up with the timing mark on the idler gear. Refer to the Specifications Manual for more information.
Illustration 2 g01292427
Ensure that the timing Marks (X) on the idler gear aligned with the timing marks on the crankshaft gear and the camshaft drive gear.
Remove Tooling (A) and Tooling (B).
Illustration 3 g01878141
Install cover (2). Install hose assembly (3) and tube assembly (4).
Illustration 4 g01011039
Install bolts (1). End By:
Install the camshaft position sensor.
Install the front cover.
Install the rocker arm and shaft.