SCREW-MACHINE 9T2966 - Caterpillar

Table 1
Contactor    Description    Setpoint    
OPLAX1     Contactor for low oil pressure at low speed    
120 kPa (17 psi)    
OPLAX2     Contactor for low oil pressure at high speed    
320 kPa (46 psi)    
FPLAX     Contactor for low fuel pressure    
140 kPa (20 psi)    
JWPLAX     Contactor for low jacket water pressure    
70 kPa (10 psi)    
AWPLAX     Contactor for low after cooler / oil cooler water pressure    
70 kPa (10 psi)    
SWPLAX     Contactor for low sea water pressure    
70 kPa (10 psi)    
Illustration 1 g00857661
Test Valve(Typical example) (1) Pressure contactor (2) Setting screw for the pressure contactor (3) Connection for a pressure contactor (4) Connection for a pressure contactor (5) Test port (6) Test valve
Turn the test valve (6) to the isolated position.
Connect an air hose to the quick connect hose fitting / test port (5) .
Apply a pressure that is 50 kPa (7 psi) higher than the specified setting of the contactor (1) to the test port (5) .
Slowly reduce the pressure. Monitor the pressure as the contactor changes states.
If the contactor (1) changes states at the specified setting within 10 kPa (1.5 psi), then the setting is good. Refer to the Testing and Adjusting, "Contactor - Adjust"section of this manual, if the contactor (1) does not change states at the specified setting.