SCREWDRIVER 1C3844 - Caterpillar

1C3844 SCREWDRIVER Caterpillar parts AP-1200, PR-1000, PR-450, PR-750B

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1C3844
1C-3844
1C3844

Weight: 1 pounds 0 kg.

Buy SCREWDRIVER 1C3844 Caterpillar genuine, new aftermarket tractor parts with delivery
ASPHALT PAVER, COLD PLANER,

Compatible equipment models: 1C3844:

ASPHALT PAVER AP-1200

COLD PLANER PR-1000 PR-450 PR-750B Caterpillar

For full view, you need register

Information:

Removal Procedure
Start By:
Remove the inlet elbow and inlet air control (NRS Induction Mixer). Refer to Disassembly and Assembly, "Inlet Air Control (NRS Induction Mixer) - Remove" for the correct procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Turn the battery disconnect switch to the OFF position.
Illustration 1 g02025312
Illustration 2 g02025313
Remove nut (3) from the terminal insulator.
Disconnect wire (4) from the terminal insulator.
Remove nuts (1) that secure busbar (2) to the glow plugs (5).
Remove the busbar from the glow plugs.
Clean the area around the glow plugs. Ensure that the area is free from contamination before removal of the glow plugs.
Remove glow plugs (5) from cylinder head (6). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 247-5377 Torque Wrench 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g02025313
Before installing glow plugs (5), ensure that the glow plugs are operating correctly. Refer to Troubleshooting, "Glow Plug Starting Aid - Test" “Check the Operation of the Glow Plugs” for the correct procedure.
Ensure that the threads of the glow plugs are clean and free from damage. Replace any damaged glow plugs.
Install glow plugs (5) into cylinder head (6). Tighten the glow plugs to a torque of 15 N m (132 lb in).
Illustration 4 g02025312
Position busbar (2) onto the glow plugs. Install nuts (1) onto the glow plugs.
Use Tooling (A) to tighten nuts (1) to a torque of 2 N m (17 lb in).
Connect wire (4) to the stud on the terminal insulator.
Install nut (3) to the stud on the terminal insulator. Tighten the nut to a torque of 6 N m (53 lb in).
Turn the battery disconnect switch to the ON position. End By:
Install the inlet elbow and inlet air control (NRS Induction Mixer). Refer to Disassembly and Assembly, "Inlet Air Control (NRS Induction Mixer) - Install" for the correct procedure.