AVSPARE.COM
parts catalog

SEAL 0005533 - Caterpillar



0005533 SEAL Caterpillar parts SEAL
Rating:
61
Alternative (cross code) number:
CA0005533
000-5533
0005533
Caterpillar 0005533 SEAL

Buy SEAL 0005533 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 7 g01078386
Refer to Operation and Maintenance Manual, "Display Description" for more information on the icons that are on the display.The following sections explain the procedure that is used in order to benchmark the AccuGrade Laser system while using the Linked Elevation Operating Mode. Refer to Operation and Maintenance Manual, "Setting the Reference Elevation" in order to use the AccuGrade Laser system and set up the AccuGrade Laser system in the Independent Elevation Operating Mode.Benchmark the System In Linked Elevation Mode
To make sure that the machine is grading to the correct elevation, the machine's cutting edge must be benched over a point that represents a finished grade. This point is known as a benchmark.Using a Level Laser
Level the machine's cutting edge.
Place the right blade tip on the benchmark.Make sure that you do not move the benchmark. If necessary, put the blade tip next to the benchmark.
Press the OK/right reset button when the right tip is on the benchmark. Both masts will begin to move automatically in order to search for the laser beam. The search for the laser beam will stop when the right laser receiver is on-grade.This process is called auto benching.Note: In order to obtain the best results, the cutting edge must be parallel to the laser beam.The following illustration shows the way the machine's cutting edge must be positioned for proper benching with a level laser.
Illustration 8 g00993191
Benching in Linked Elevation Operation Mode (Level Laser) (1) Laser Receivers (2) BenchmarkRefer to Operation and Maintenance Manual, "Setting the Reference Elevation" in order to benchmark the machine's cutting edge with a sloping laser.Set the Reference Elevation
The elevation of the benchmark must be entered into the Display. In order to enter the elevation, proceed through the following steps.
Illustration 9 g00993453
Place the power/setup switch on the display in the "i" position. The screen in Illustration 9 appears. Refer to Operation and Maintenance Manual, "Display" for more information on the buttons and switches on the display.
Toggle either


Parts seal Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.