SEAL 0007672 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A FT-1952 Axle Removal Tool 1 Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g00870292
Remove bolts (1) and cover (2).
Illustration 2 g00871054
Illustration 3 g00871057
Use Tooling (A) to remove outer axle (3) and inner axle (4).Note: This machine has two axles on the left side of the machine and one axle on the right side of the machine.Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A FT-1952 Axle Installation Tool 1
B 396–9451 Petro Gel Amber Grease 1 Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 4 g06120222
Illustration 5 g06120218
Illustration 6 g06120210
Apply Tooling (B) at locations (X).Note: Remove all burrs from axles (4) before applying Tooling (B).
Illustration 7 g00871057
Illustration 8 g00871054
Use Tooling (A) to install inner axle (4) and outer axle (3).Note: This machine has two axles on the left side of the machine and one axle on the right side of the machine.
Illustration 9 g00870292
Install cover (2) and bolts (1).