SEAL 0301927 - Caterpillar

5.0 Implement/Attachment Inspection
Table 6
Sl.No. Status(1) Description Comments
5.1 Blade and trunnion ball joints, and stabilizer bar
5.2 C-Frame
5.3 Blade Lift Cylinder
5.4 Blade Angle Cylinder
5.5 Blade Tilt Cylinder
5.6 Blade cutting edges and end bits
5.7 Ripper
5.8 Ripper lift cylinders
(1) N = Normal, M = Monitor, A = Action, Blank = Not ApplicablePerformance Inspection
Hydraulic Performance Checks
Cylinder Speed Tests
Table 7
Status(1) Description Specification Actual Comments
Bulldozer Tilt Cylinder Speed Test
Type of Blade
Full Tilt Right to Full Tilt Left
Full Tilt Left to Full Tilt Right
Bulldozer Lift Cylinder Speed Test
Ground to Fully Raised
Bulldozer Angle Cylinder Speed Test
Full Angle Right to Full Left
Full Angle Left to Full right
Ripper Cylinders Speed Test
Full Down to Full Up
(1) N = Normal, M = Monitor, A = Action, Blank = Not ApplicableCylinder Drift Tests
Table 8
Status(1) Description Specification Actual Comments
Oil Temperature
Bulldozer Lift Cylinders Drift Test
Bulldozer Tilt Cylinders Drift Test
Ripper Lift Cylinders Drift Test
(1) N = Normal, M = Monitor, A = Action, Blank = Not ApplicableService Brake Holding Ability (Test from OMM)
Table 9
Status(1) Description Specification Actual Comments
Service Brake Holding Ability Test
(1) N = Normal, M = Monitor, A = Action, Blank = Not Applicable