SEAL 0812647 - Caterpillar

Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Table 1
REQUIRED TOOLS
Tool Part Number Part Description Qty
A 4C-9910 Portable Hydraulic Tester
48200 kPa (7000 psi)
13 L/min to 473 L/min (4 US gpm to 125 US gpm) 1
9U-5228 Union
(1) 2
(1) Additional fittings may be required. Check your host machine for the proper mating parts.
Illustration 1 g01959978
(1) Inlet line
(2) Portable Hydraulic Tester
(3) Back Pressure Gauge
(4) Return line
Lower the boom to the ground and stop the engine of the host machine. Relieve the pressure from the hydraulic system. Refer to Testing and Adjusting for the host machine.Note: Before you use 4C-9910 Portable Hydraulic Tester, read the user's manual for proper utilization. Be sure to understand the operation of the tester and the maintenance of the tester before usage.
Connect 4C-9910 Portable Hydraulic Tester (2) to inlet line (1) and to return line (4).
Start the host machine. Run the host machine at high idle until the hydraulic oil reaches the normal operating temperature of 55° 5°C (131° 9°F). All testing must be done at maximum engine rpm, maximum power level, and maximum work mode.
Gradually close the orifice valve on the hydraulic tester until operating pressure is reached. Refer to Table 2 for the operating pressure.
Table 2
Function Operating Pressure
OPEN/CLOSE OPERATION 32000 to 35000 kPa (4640 to 5075 psi)
Record the reading from the hydraulic flow tester. Refer to Table 3 for the proper specifications. If necessary, adjust the flow. Refer to Service Manual for the host machine for the proper procedure. The flow must be within the specifications at the normal operating pressure of the work tool.
Record the back pressure reading from pressure gauge (3) on the Service Record for the work tool. Refer to Operation and Maintenance Manual, "Work Tool Installation" for the service record. If the pressure exceeds the specification, check the return side of the system for a restriction.
After adjustments have been made, stop the engine on the host machine and relieve the hydraulic pressure. Remove the tooling from the hose assemblies.
Table 3
Specifications for OPEN/CLOSE OPERATION
Sales Model Oil Flow Operating Pressure(1) Maximum Recommended Back Pressure(2)
G210 GC/ G210 GC (TRS) 60 L/min