SEAL GP 0996463 - Caterpillar

Illustration 6 g02166554
Install bonnet (29).
Illustration 7 g02166473
Connect hose assemblies (28). Attach cable strap (27).
Illustration 8 g02166420
Install the flange and bonnet (25). Install support (24). Connect hose assembly (26).
Illustration 9 g02166217
Install tube assembly (22). Install heat shields (23)
Illustration 10 g02166214
Connect hose (21).
Illustration 11 g02166153
Install tube (20) and tube hump (19). Tighten the clamp for tube hump (19) to a torque of 7.5 1.0 N m (66.38 8.85 lb in).
Illustration 12 g02241016
Install shield assemblies (18).
Illustration 13 g02240973
Attach a suitable lifting device to exhaust cooler (10). The weight of exhaust cooler (10) is approximately 23 kg (50 lb). Use the suitable lifting device in order to install exhaust cooler (10). Install bolts (17).
Illustration 14 g02240954
Looking up from the bottom of the machine.
Connect tube assembly (15) to exhaust cooler (10). Install clip (16).
Illustration 15 g02240941
Looking up from the bottom of the machine.
Install the clips and bolts (13). Connect elbow (14) to exhaust cooler (10).
Illustration 16 g02240933
Install new bellows (12) and new V-clamps (11) to exhaust cooler (10). Tighten new V-clamps (11) to a torque of 8.5 1.0 N m (75.23 8.85 lb in).
Illustration 17 g02240911
Connect tube assembly (9). Install a new V-clamp (8). Tighten new V-clamp (8) to a torque of 8.5 1.0 N m (75.23 8.85 lb in). Install clamp (7).
Illustration 18 g02240906
Install heat shields (6). Install heat sensors (5). Tighten heat sensors (5) to a torque of 45 5 N m (33 4 lb ft).
Illustration 19 g02240898
Install tube assembly (3) and a new clamp (2). Install bolt (). Tighten clamp (2) with a maximum wrench speed of 75 RPM to a torque of 55 8 N m (41 6 lb ft).
Illustration 20 g02240894
Install heat shields (1). End By:
Install the turbocharger on the left side of the machine.
Install the crankcase guard.
Disconnect the steering frame lock.