SEAL KIT 1148526 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments , the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption , service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Extender (ELC) - Add
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Storage Procedure - Check
Fuel System - Prime
Daily
Coolant Level - Check
Every Week
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fuel Tank Water and Sediment - Drain
Grounding Stud - Inspect/Clean/Tighten
Jacket Water Heater - Check
Power Take-Off Clutch - Check
Walk-Around Inspection
Every 50 Service Hours or Weekly
Zinc Rods - Inspect/Replace
Initial 250 Service Hours
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Fuel Injector - Inspect/Adjust
Every 500 Service Hours
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 500 Service Hours or 1 Year
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Coolant Sample (Level 2) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Mounts - Inspect
Fuel System Primary Filter (Water Separator) Element - Replace
Hoses and Clamps - Inspect/Replace
Every 3000 Service Hours or 3 Years
Aftercooler Core - Clean/Test
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Driven Equipment - Check
Engine - Clean
Engine Protective Devices - Check
Heat Exchanger - Inspect
Every 15 000 L (4000 US gal) of Fuel or 500 Service Hours or 1 Year
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fuel System Primary Filter - Replace
Fuel System Secondary Filter - Replace
Every 28 500 L (7500 US gal) of Fuel or 3000 Service Hours
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Fuel Injector - Inspect/Adjust
Every 760,000 L (200,770 US gal) of Fuel
Overhaul Considerations