SEAL 1149510 - Caterpillar

Water Separator (If Equipped)
Check Level
The water separator is located in front of the radiator. Open the access door at the left side of the machine. 1. If the red ring in the bowl reaches the level line, loosen the valve at the bottom of the body and drain the water and sediment.2. Dispose of drained material according to local regulation. Before draining the water and sediment, be sure to fill the fuel tank with fuel.Fuel Tank
Drain the Water and Sediment
Dispose of drained material according to local regulations. 1. Open the drain valve located under the fuel tank and allow the water and sediment to drain into a container.2. Close the drain valve.Fill Fuel Tank
Fuel can be added to the tank by removing the fill cap on top of the fuel tank and using an electric fuel refueling pump (if equipped).After completion of refueling, be sure to lock the fuel tank cap to protect against vandalism.Walk-Around Inspection
Inspect Machine
Accumulated grease and oil on a machine is a fire hazard. Remove this debris with steam cleaning or high pressure water, at least every 1000 hours or each time any significant quantity of oil is spilled on a machine.
Keep a close watch for leaks. If leaking is observed, find the source and correct the leak. Check the fluid levels more frequently than the recommended periods if leaking is suspected or observed. Inspect the implement cylinders, linkage and bucket for damage or excessive wear. Repair if damaged. Inspect lights for broken bulbs and lenses. Replace if broken. Inspect and remove any trash build up in the engine compartment.Inspect the cooling system for leaks, faulty hoses and trash build up. Correct any leaks and remove any trash from the radiator.Inspect all engine attachment belts for worn cracked or frayed edges. Replace if worn, cracked, frayed or broken. Check the air filter restriction indicator. If the indicator is in the red zone, service the engine air filter.After servicing, push the reset button to reset the filter indicator. Inspect the hydraulic system for leaks. Inspect the tank, cylinder rod seals, hoses, tubes, plugs, joints and fittings. Correct any leaks.Inspect and repair any final drive leaks. Check the oil level if leakage is noticed.Inspect and repair any swing drive leaks.Be sure covers and guards are firmly in place. Inspect for damage.Inspect the steps, walkways and handholds for their condition and cleanliness. Repair or clean if necessary. Inspect the Falling Objects Protective Guard (if equipped) for damage. Tighten any loose bolts. Repair if necessary.Inspect the operator's compartment for cleanliness. Keep it clean.Adjust the rear view mirrors for best vision.Window Cleaning
Use commercially available window cleaning solutions to clean the windows. Clean the outside windows from the ground, unless handholds are available.Cleaning Methods
Aircraft Windshield Cleaner - Apply the cleaner with a soft cloth. Rub with moderate pressure until all dirt is removed. Allow the cleaner to dry. Wipe off with a clean soft cloth. Soap and Water - Use a clean sponge or soft cloth. Wash windows with a mild