SEAL-RING 1237264 - Caterpillar

Removal Procedure
Start By:
Disconnect the fuel supply to the engine.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00598913
Typical
Remove the protective cover from the lifting brackets. Mark the location of the lifting brackets.
Remove fuel injection line (1). Plug the openings with 4C-9517 Plugs in order to prevent debris from entering the fuel port.
Remove four nuts (3).
Remove lifting bracket (2). Note: Store the lifting brackets in a clean dry place. Do not install the lifting brackets until it is necessary to lift the engine.
Install 185-5192 Stud Protectoron each cylinder head stud. Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Remove 185-5192 Stud Protector from each cylinder head stud.
Install the engine lifting brackets on a 3612 Engine between the following cylinders:
Number 1 Cylinder and Number 3 Cylinder
Number 2 Cylinder and Number 4 Cylinder
Number 9 Cylinder and Number 11 Cylinder
Number 10 Cylinder and Number 12 Cylinder
Install the engine lifting brackets on a 3616 Engine between the following cylinders:
Number 1 Cylinder and Number 3 Cylinder
Number 2 Cylinder and Number 4 Cylinder
Number 13 Cylinder and Number 15 Cylinder
Number 14 Cylinder and Number 16 Cylinder
Put 5P-3931 Anti-Seize Compound on the threads of the cylinder head studs.
Put engine lifting bracket (2) in position on the cylinder head studs. Install four nuts (3). Tighten the nuts to a torque of 2150 250 N m (1590 185 lb ft). Note: The brackets must be installed so that the pin holes in the clevis are in a horizontal plane.
Install fuel line (1). End By:
Connect the fuel supply to the engine.