SEAL 1296590 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01009468
Illustration 2 g01185803
Illustration 3 g00676791
Position the gasket and engine oil filter base (4) on the cylinder block.
Install the washers and bolts (2) that hold engine oil filter base (4) to the cylinder block. Tighten the bolts according to the following procedure:
Tighten Bolt (1) through Bolt (15) in a numerical sequence to a torque of 15 N m (11 lb ft).
Tighten Bolt (1) through Bolt (15) in a numerical sequence to a torque of 28 N m (21 lb ft).
Apply lubricant to new O-ring seal (5) . Install O-ring seal (5) in the fitting on the engine oil filter base.
Connect tube assembly (1) to engine oil filter base (4) .Note: Never install an oil filter with a wrench. Follow the instructions on the oil filter.
Put a coat of fresh oil on the O-ring seal for the engine oil filter. Install engine oil filter (3) on engine oil filter base (4) by hand.
After the O-ring seal contacts engine oil filter base (4) , turn engine oil filter (3) for 3/4 of a turn.End By: Install the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".