1333234 SEAL Caterpillar parts
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 37...
Rating:
Alternative (cross code) number:
CA1333234
133-3234
1333234
CA1333234
133-3234
1333234
Weight: 0.01 pounds 0 kg.
ARTICULATED TRUCK, WHEELED EXCAVATOR,
This part in 2 request:
Show.
This information for suppliers only!
2022-04-07
2019-09-14
Compatible equipment models: 1333234:
EXCAVATOR
312D
315D L
319D
323D L
323D LN
324D
324D L
324D LN
325C
325D
325D L
329D L
330C L
330D L
330D LN
330D MH
336D L
336D LN
345C
345C L
345D
345D L
365C
365C L
365C L MH
374D L
385C
385C FS
385C L
385C L MH
390D
390D L
M325D L MH
M325D MH
FRONT SHOVEL
385C
PIPELAYER
PL61
Number on catalog scheme:
49
For full view, you need register
Information:
Illustration 1 g03333253
The FMI 02 means that the machine control module (MCM) has determined that the ground speed sensor (distance measuring instrument or DMI) is not communicating properly.Note: The following test procedure may create other diagnostic codes. Ignore these diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of cid 0084 fmi 02 is active before performing this procedure.Test Step 1. CHECK THE WIRING HARNESS.
Turn the key start switch and the disconnect switch remain in the OFF position.
Disconnect the machine harness connector from the DMI, connector AR-C2.
Disconnect the CF-C1 connector of the left-hand transmission output speed sensor.
At the machine harness connector for the sensor, install a jumper between contact 5 and contact 6.
At the machine harness connector for the DMI, measure the resistance from contact 1 (wire J992-YL) and contact 3 (wire J993-PK).Expected Result:The resistance that is measured is less than 50 ohms.Results:
YES - The resistance that is measured is less than 50 ohms. The resistance of the harness is correct. Proceed to test step 2.
NO - The resistance measures more than 5000 ohms. The machine harness has failed.Repair: There is an open in one of the signal wires, wireJ992-YL or wire J993-PK. Repair the harness or replace the harness.STOPTest Step 2. RESTART AUTONOMY SYSTEM.
Power off and power back on the autonomy system and all related components. Allow ample time for each component to power on and establish communications.
Check the status of mid 039 cid 0084 fmi 02.Expected Result:The mid 039 cid 0084 fmi 02 is no longer active.Results:
OK - The diagnostic code is no longer active.Repair: A communications error may have occurred during startup of the system. By restarting the system, the DMI has established proper communications.STOP
NOT OK - The diagnostic code is STILL active.Repair: It is unlikely the DMI has failed. Repeat this test procedure to ensure that the DMI has failed. Repair or replace the DMI.STOP
Cat SIS web machinery list:
Parts seal Caterpillar catalog:
330C, 330C FM, 330C L, 330C MH
328D LCR, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F L, 340D L, 340D2 L, 345C MH, 345D L, 349D L, 349E, 349E ...
330C, 330D L, 330D MH, 345B II, 345B II MH, 345B L, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L
330C, 330D L, 330D MH, 345B II, 345B II MH, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L HVG, 349E L VG, 349F L, 374D L, 374F L
345B II, 345C, 345C L, 365B, 365B II, 365C, 365C L, 365C L MH, 374D L, 374F L
365B, 365B II, 365C, 365C L, 374D L, 374F L, 385B, 385C, 385C L, 390D, 390D L, 390F L
365B, 365B II, 365C, 365C L, 374D L, 374F L, 385B, 385C, 385C L, 390D, 390D L, 390F L
365B, 365B II, 365B L, 365C, 365C L, 365C L MH, 374D L, 374F L
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 365B II, 365C, 365C L, 374D L, 374F L, 385B, 385C, 385C L, 390D, 390D L, 390F L
385B, 385C, 385C L, 390D, 390D L
328D LCR, 345B II, 345B L, 345C, 345C L, 345D L, 349E L, 349E L VG, 349F L, 350, 365B, 365B II, 365B L, E650
365C, 374D L, 374F L, 385B, 385C, 385C L, 390D, 390D L, 390F L
3722151
SEAL-BUFFER
319D L, 319D LN, 320B, 324D, 324D FM, 324D L, 324D LN, 324E L, 324E LN, 325C, 329E L, 329E LN, 330B L, 330C, 345B L
319D L, 319D LN, 320B, 324D, 324D FM, 324D L, 324D LN, 324E L, 324E LN, 325C, 329E L, 329E LN, 330B L, 330C, 345B L
319D L, 319D LN, 320B, 324D, 324D FM, 324D L, 324D LN, 324E L, 324E LN, 325C, 329E L, 329E LN, 330B L, 330C, 345B L
319D L, 319D LN, 320D, 320D FM, 320D L, 320D2, 320D2 L, 320E LN, 323D L, 323D LN, 323D SA, 323D2 L, 323E L, 324D, 324D FM, 324D L, 324E, 324E L, 324E LN, 325D, 325D L, 326D L, 328D LCR, 329D, 329D L, ...
319D L, 319D LN, 320D, 320D FM, 320D L, 320D2, 320D2 L, 320E LN, 323D L, 323D LN, 323D SA, 323D2 L, 323E L, 324D, 324D FM, 324D L, 324E, 324E L, 324E LN, 325D, 325D L, 326D L, 328D LCR, 329D, 329D L, ...
3640948
SEAL-BUFFER
319D L, 319D LN
319D L, 319D LN
3640949
SEAL-U-CUP
319D L, 319D LN
319D L, 319D LN
2476838
SEAL
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 37...
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 37...
2476839
SEAL
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 37...
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 37...
2521244
SEAL
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 37...
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 37...
2826523
SEAL
319D, 323D L, 323D LN, 324D, 324D LN, 325D, 325D L, 329D L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 385C, 385C L, M313D, M315D, M316D, M31...
319D, 323D L, 323D LN, 324D, 324D LN, 325D, 325D L, 329D L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 385C, 385C L, M313D, M315D, M316D, M31...
1721681
SEAL
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 37...
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D L, 324D LN, 325C, 325D, 325D L, 329D L, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336D LN, 345C, 345C L, 345D, 345D L, 365C, 365C L, 365C L MH, 37...
2627935
SEAL
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D LN, 325D, 325D L, 329D L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336E HVG, 345C, 345C L, 345D, 345D L, 349E L HVG, 365C, 365C L, 365C L MH, 374D L, 385...
312D, 315D L, 319D, 323D L, 323D LN, 324D, 324D LN, 325D, 325D L, 329D L, 330D, 330D L, 330D LN, 330D MH, 336D L, 336E HVG, 345C, 345C L, 345D, 345D L, 349E L HVG, 365C, 365C L, 365C L MH, 374D L, 385...