SEAL 1358280 - Caterpillar

Connect communications adapter (C) to the laptop computer.
Start the Caterpillar Electronic Technician (ET).
Select the "Transmission ECM" option from the pull-down menu.
Select "OK".
Select the "Service" option from the pull-down menu.
Select the "Calibrations" option from the pull-down menu.
Select the "Implement Control Lever Calibration" option from the pull-down menu.
The "Select Components To Calibrate" screen will display the following options:
"Bowl Lever Sensor Calibration"
"Ejector Lever Sensor Calibration"
"Apron Lever Sensor Calibration"All the above options will be selected when the procedure is started.
Select the "Begin" option.
Illustration 55 g02022207
Calibration screen
Follow the instructions that are on the screen. The following instructions are on the screen:
"Set the parking brake."
"Engine speed should be 0 rpm."
"Release the implement control lever so that the implement control lever is in the neutral position."
"Move the implement control lever to the full Bowl Up position. While holding in this position, press and release the Cushion Hitch button."
"Move the implement control lever to the full Bowl Down position (past the detent to the end of travel). While holding the lever in this position, press and release the Cushion Hitch button."
Illustration 56 g02022209
Calibration screen for the sensor for the lever that adjusts the bowl
Illustration 57 g02022211
(4) Implement control lever
(5) Cushion-hitch button
After