SEAL-O-RING 1400226 - Caterpillar

1400226 SEAL-O-RING Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1400226
140-0226
1400226

Weight: 0.01 pounds 0 kg.

Information:

CROSS SECTION DIAMETER 3 mm

ID 120 mm

MATERIAL Nitrile (NBR) Rubber 90 Duro

OD 0 mm

Buy SEAL-O-RING 1400226 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Heath Outdoor Products 1400226 Mini Nylon Bunting USA Flag Brass Rust-Resistant Grommets, 1.5-Inch by 3-Feet

$4.88

10 Apr 2021

-: -

Heath Outdoor Products 1400226 Mini Nylon Bunting USA Flag Brass Rust-Resistant Grommets, 1.5-Inch by 3-Feet
Mini nylon bunting USA flag 1.5-inch By 3-feet || Brass rust-resistant grommets || Made in USA. High quality, shiny nylon for strength and durability || Deep, bright colors resistant to UV fading

CTP Caterpillar Nbr (90) O-Ring (1400226) Aftermarket

$8.29

11 Feb 2020
0.110231131[0.00] Pounds
-: -

CTP Caterpillar Nbr (90) O-Ring (1400226) Aftermarket

Number on catalog scheme: 14

Caterpillar 1400226 Parts scheme SEAL-O-RING

For full view, you need register

Information:

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Drain" for the correct procedure.
Illustration 1 g03338656
Disconnect harness assembly (1) from coolant temperature sensor (2).
Use a deep socket in order to remove coolant temperature sensor (2) from water temperature regulator housing (4).
Remove sealing washer (3) (not shown) from coolant temperature sensor (2). Installation Procedure
Ensure that all components are clean and free from damage. Replace any components that are worn or damaged.
Illustration 2 g03338656
Install a new sealing washer (3) (not shown) to coolant temperature sensor (2).
Use a deep socket in order to install coolant temperature sensor (2) to water temperature regulator housing (4). Tighten the coolant temperature sensor to a torque of 29 N m (257 lb in).
Connect harness assembly (1) to coolant temperature sensor (2).
Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Fill" for the correct procedure.