SEAL-SHAFT 1441083 - Caterpillar

1. Remove two bolts and washers (1) and clip (2) from the rear of the transmission housing. Remove cover (3) from the transmission housing. 2. Disconnect wire assembly (4) from transmission speed sensor (5). 3. Remove nut (6) that holds transmission speed sensor (5) to the transmission housing. Remove transmission speed sensor (5) from the transmission housing. The following steps are for the installation of the transmission speed sensor.4. Install transmission speed sensor (5) to the transmission housing. It is recommended to maintain an air gap of 0.89 mm (.035 in) between the gear and transmission speed sensor (5). Tighten nut (6) to a torque of 25 5 N m (18 4 lb ft).5. Connect wire assembly (4) to transmission speed sensor (5).6. Position cover (3) to the transmission housing. Position clip (2) to the transmission housing. Install two bolts and washers (1) that hold cover (3) to the transmission housing. Tighten bolts (1) to a torque of 55 10 N m (40 7 lb ft).