SEAL-O-RING 1470182 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 177-8001 Pilot Sleeve 2
B 249-2936 Adapter 1
C 274-7932(1) or 274-7933(2) Guide 1
D 8T-2998 Lubricant 1
(1) Front Removal
(2) Rear Removal
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Do not turn the crankshaft or the camshaft while the camshaft gear is removed. If the rear gear group is not correctly timed during installation, interference can occur between the pistons and the valves, resulting in damage to the engine.
Care must be used when removing or installing the camshaft. Do not damage the finished surfaces of the camshaft or the camshaft bearings.
Ensure that the camshaft and camshaft bearings are thoroughly clean. Lubricate the camshaft lobes with a 50/50 mixture of Tooling (D) and clean engine oil. Apply a thin coat of clean engine oil on the camshaft bearings.
Illustration 1 g01160265
Install Tooling (A) and Tooling (B) on the rear of camshaft (15). Install Tooling (A) on the front of camshaft (15).
Install Tooling (C) on the front housing or the rear housing. Tooling (C) is used to support the camshaft.
Use two technicians to install the camshaft. Use Tooling (C) to help with aligning the camshaft with the camshaft bearings. Carefully slide the camshaft into the cylinder head. Keep the camshaft level while the camshaft is being installed in the cylinder head. The weight of the camshaft is approximately 35 kg (77 lb).Note: Rotate the camshaft during installation. This will prevent the camshaft from binding in the camshaft bearings.
Remove Tooling (A) and Tooling (B) from the camshaft.
Illustration 2 g01160261
Install adapter assembly (14) and sealing plate (13). Install bolts (12).
Illustration 3 g01160259
Illustration 4 g01151441
Install damper (11) and bolts (10).
Tighten the bolts to a torque of 240 40 N m (177 30 lb ft). Tighten the bolts in the following sequence: 1, 4, 2, 5, 3, 6, 1, 4.
Illustration 5 g01160256
Install cover (8) and elbow (9).
Illustration 6 g01222314
Install new O-ring seals and sealing plate (7).
Illustration 7 g01222233
Install adapter assembly (6), thrust plate (5), and bolts (4).
Illustration 8 g01222230
Illustration 9 g01151468
Install gear (3) and bolts (2). Refer to Testing and Adjusting, "Rear Gear Group- Time" for the correct timing procedure.
Tighten the bolts to a torque of 240 40 N m (177 30 lb ft). Tighten the bolts in the following sequence: 1, 4, 2, 5, 3, 6, 1, 4.
Illustration 10 g01222228
Install cover (1).
Fill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".End By:
Install the rocker arms and the rocker shafts. Refer to Disassembly and Assembly, "Rocker Arms and Shaft - Install".