SEAL GP-DUO CONE 1483533 - Caterpillar

Never run the engine without an air cleaner element installed. Never run the engine with a damaged air cleaner element. Do not use air cleaner elements with damaged pleats, gaskets or seals. Dirt entering the engine causes premature wear and damage to engine components. Air cleaner elements help to prevent airborne debris from entering the air inlet.
Type 1
Note: Use the 102-9720 Cleaning Kit. This product contains the detergent and oil that is made specifically for the maintenance of the air cleaner elements.
Illustration 1 g00898593
(1) Air cleaner element
Illustration 2 g00898590
(1) Latches
(2) CoverNote: This type of air cleaner element should be replaced after three cleanings.
Remove the air cleaner element (1). Tap the air cleaner element to dislodge dirt particles. Gently brush the air cleaner element with a soft bristle brush.
Do not use gasoline, steam, caustic or unapproved detergents, or parts cleaning solvents. Do not use high pressure water or air to clean the air cleaner element. Any of those liquids or methods can cause air cleaner element damage.
Spray the air cleaner element with the cleaning solution. Allow the air cleaner element to stand for 10 minutes.
Rinse the air cleaner element with low water pressure. The maximum water pressure for this procedure is 275 kPa (40 psi). Tap water is acceptable. Start to rinse the air cleaner element from the clean side (inside). Next, clean the dirty side (outside) to flush out dirt. Inspect the air cleaner element for tears and/or holes after the air cleaner element is cleaned. Do not reuse damaged air cleaner elements.
Do not use compressed air, open flame, or hot air to dry the air cleaner element. Excess heat shrinks cotton fiber, and compressed air may blow holes in the material. Allow the air cleaner element to air dry.
Shake excess water off the air cleaner element , and allow the air cleaner element to air dry. Drying the air cleaner element in the sun speeds the process.
Do not use transmission fluid, engine oil, diesel fuel, or other lubricant to oil the air cleaner element. The air cleaner element can not function correctly if improper oil is used. Never operate an engine with a dry air cleaner element. The air cleaner element can not function correctly without oil. Always saturate the clean air cleaner element with the recommended oil.
The dry air cleaner element should be oiled before installation. Apply small amounts of oil across the top of each pleat. Allow the oil to soak into the air cleaner element for 20 minutes. Oil any remaining "white" spots.
Inspect the housing and the clamp for air cleaner element (1). Install the clean, oiled air cleaner element. Replace the housing and the clamp, if necessary. Refer to Specifications, SENR3130, "Torque Specifications" for the proper torque of the clamp.Type 2
Illustration 3 g01836856
(1) Latches
(2) Cover
Disconnect latches (1).
Remove cover (2).
Remove the air cleaner element.Note: This type of air cleaner element may be cleaned up to six times.
Refer to Guideline for Reusable Parts and Salvage Operations, SEBF8062 for cleaning instructions or replace the