SEAL 1506372 - Caterpillar

Illustration 1 g00949330
Illustration 2 g00949327
There are several specific messages on this machine. The exact location of the messages and the description of the messages are reviewed in this section. Please become familiarized with all messages.Make sure that all of the messages are legible. Clean the messages or replace the messages if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the messages, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. Loose adhesive will allow the messages to fall.Replace any message that is damaged, or missing. If a message is attached to a part that is replaced, install a message on the replacement part. Any Caterpillar dealer can provide new messages.Fuel Filler (1)This message is located on the filler tube for the fuel tanks.
Illustration 3 g00907956
Use only a Caterpillar approved fast fill system to fuel machines. Over pressurization may cause tank deformation and fuel spillage.Contact your Cat dealer for fast fill system availability.
No Step (2)If equipped, this message is located on the guard for each fuel tank. This message is also located on each fuel tank.
Illustration 4 g00906093
Do not use the fuel tank as a step. The surface is not covered with a nonslip tread.Do Not Weld the Frame. (3)This message is located on the left side of the front frame behind the lift cylinder bracket.
Illustration 5 g00906095
Do not drill or weld top or bottom plates of main frame.Air Conditioner (4)This message is located on the front of the air conditioner under the operator's seat.
Illustration 6 g00939074
Read the service manual before you perform any maintenance on the air conditioner.Alternate Exit (5) If your machine is equipped with a snow wing, this message is located on the left ROPS support at the rear of the operator's compartment.
Illustration 7 g00907967
If the primary exits are blocked, use the hammer to break the window. Exit the machine through the window.Do Not Weld the ROPS. (6)This message is located on each ROPS support assembly at the rear of the operator's compartment.
Illustration 8 g00906117
Do not weld the ROPS. Do not drill the ROPS. Read the service manual before you perform any work on the ROPS.Air Cleaner (7)This message is located on the cover of the air cleaner. The air cleaner is located inside the engine compartment on the right side of the machine.
Illustration 9 g00949322
To avoid engine damage, use only Caterpillar radial seal air filters as replacement filters. Refer to the following topics for correct replacement instructions:
Operation and Maintenance Manual, "Engine Air Filter Primary Element - Clean/Replace"
Operation and Maintenance Manual, "Engine Air Filter Secondary Element - Replace"