SEAL-BULK 1528318 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
ZZ     6V-9510     Face Seal Plug     1    
6V-9831 Cap As     1    
6V-9507 Face Seal Plug     1    
6V-9828 Cap As     1    Start By:
Remove the air compressor. Refer to Disassembly and Assembly, "Air Compressor - Remove and Install".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Illustration 1 g01037930
Disconnect tube assembly (4) .
Disconnect hose assembly (5) .
Disconnect harness assembly (3) .
Remove bolts (1) .
Remove unit injector hydraulic pump (2) .Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 2 g01037930
Install unit injector hydraulic pump (2) .
Install bolts (1) .
Connect harness assembly (3) .
Connect hose assembly (5) .
Connect tube assembly (4) .End By: Install the air compressor. Refer to Disassembly and Assembly, "Air Compressor - Remove and Install".