SEAL-O-RING 1531157 - Caterpillar

Generator Set: C175-16 (S/N: WYB1-UP)Engine: C175-16 (S/N: WYC1-UP; P6L1-UP; R1X1-UP) C175-20 (S/N: BXR1-UP)Introduction
Inspections are a basic form of condition monitoring. Proactive monitoring and analysis of equipment information will allow dealers to intervene before problems occur.The specifications that are provided in this publication are typical. Actual measurements from your engine may differ slightly.Creating an Electronic Copy
Use the following procedure to create an editable electronic copy from SIS Web.
Click format to print.
Save the document as an HTML format.
Open the document with Microsoft Word.Engine Systems
Cooling System
Table 1
Status (1)     Description     Specification     Actual     Comments    
    Radiator Pressure Relief (Radiator Cap) (2)     -            
    Freezing Point of Engine Coolant     -            
    Conditioner Test of Engine Coolant     -            
    Belt Tension     -         Refer to the Operation and Maintenance Manual    
    Difference between the Upper and Lower Radiator Tank Temperatures     -            
( 1 ) N = Normal, M = Monitor, A = Action
( 2 ) Test for the pressure that is listed on the cap.Fuel System
Table 2
Status     Description     Specification     Actual     Comments    
    Fuel Pressure     90 20 kPa (13 3 psi)            Lubrication System
Table 3
Status     Description     Specification     Actual     Comments    
    Engine Oil Pressure at Low Idle    
375 75 kPa (54 10 psi)            
    Engine Oil Pressure at High Idle    
700 100 kPa (101 14.5 psi)            Basic Engine
Table 4
Status (1)     Description     Specification     Actual     Comments    
    Engine Speed at High Idle     1800 10 rpm
or
1500 10 rpm            
    Engine Speed at Low Idle     900 10 rpm            
    Cylinder Cutout Test     -         Caterpillar Electronic Technician (ET)    
    Engine Crankcase Blowby Pressure     -            
( 1 ) N = Normal, M = Monitor, A = ActionAir Inlet and Exhaust System
Table 5
Status (1)     Description     Specification     Actual     Comments    
    Cylinder # 1 Exhaust Temperature (2)     -            
    Cylinder # 2 Exhaust Temperature (2)     -            
    Cylinder # 3 Exhaust Temperature (2)     -            
    Cylinder # 4 Exhaust Temperature (2)     -            
    Cylinder # 5 Exhaust Te