SEAL-O-RING 1548741 - Caterpillar

System Settings Factory Default
Table 1
System Voltage     Volt     480/600/4160    
System Frequency     Hz     60    
System KW Ramp Rate     kW     25    Generator Factory Default Setup Settings
Table 2
Rated Voltage     Volt     480/600/4160    
Rated KW     kW     1000    
Rated kVAR     kVAR     1000    
Cooldown     Min     5    
Engine Safety Alarm     Sec     15    
Bus VT Primary     Volt     480/600/4200    
Bus VT Secondary     Volt     480/120/120    
CT Primary         1500    
NGR CT Primary         20    
Voltage Measure Type         0 = 3 phase 4 wire    
Speed Droop Setpoint     Hz     60    
Lower Voltage (Gen available)     percent of rated voltage     90    
Upper Voltage (Gen available)     percent of rated voltage     1100    
Lower Frequency (Gen available)     percent of rated frequency     90    
Upper Frequency (Gen available)     percent of rated frequency     110    Generator Protective Settings
Table 3
Reverse kW Alarm Class         5 = F    
Reverse kW Setpoint     percent of rated kW     -5    
Reverse kw Time Delay     Sec     3    
Over Excitation Alarm Class         5=F    
Under/Over Excitation Setpoint     percent of rated Frequency     20    
Over Excitation Time Delay     sec     10    
Under Excitation Time Delay     sec     10    
Over Voltage Alarm Class         5 = F    
Over Voltage Setpoint     percent of rated Voltage     112    
Over Voltage Time Delay     sec     3    
Under Voltage Alarm Class         5 = F    
Under Voltage Setpoint     percent of rated Voltage     88    
Over Frequency Alarm Class         5 = F    
Over Frequency Setpoint     percent of rated Frequency     115    
Over Frequency Time Delay     sec     3    
Under Frequency Alarm Class         5 = F    
Under Frequency Setpoint     percent of rated Frequency     85    
Under Frequency Time Delay     sec     3    Gen Circuit Breaker Settings
Table 4
CB Fail to Open Delay     ms     500    
CB Fail to Close Delay     ms     500    
CB Fail to Synchronize Delay     sec     90    
Voltage Window     percent of rated voltage     3    
CB On Impuls     ms     250    
CB On Impuls     ms     250    
Dwell Time     ms     250    
Positive Phase Window     Hz     0.04    
Negative Phase Window     Hz     -0.04    
Positive Slew Rate     deg     7    
Negative Slew Rate     deg     -7    Load Shed Settings
Table 5
Remove Delay     min     10    
Add Delay     sec     30    
Load Stabilization     min     10    
Minimum Reserve     kW     2000    
Immediate Add Reserve     kW     500    
Remove Differential     kW     2000