SEAL GP-DUO-CONE 1559879 - Caterpillar

Before performing any operation or maintenance procedures, ensure that the Safety Information, warnings, and instructions are read and understood.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must be performed.Experience has shown that maintenance intervals are most accurately based on fuel consumption. Fuel consumption corresponds more accurately than service hours to the engine load. For a list of the average ranges of fuel consumption and the service hours for a load factor of 25 percent, refer to Operation and Maintenance Manual, "Maintenance Recommendations" (Maintenance Section).Note: For maintenance information for the triplex pump, refer to the"OEM Service Manual" .Note: For maintenance information for the transmission, refer to the"OEM Service Manual" .When Required
Engine - Clean
Engine Air Cleaner Element (Single Element) - Clean/Replace
Fuel System - Prime
Heat Exchanger - Clean
Daily
Air Tank Moisture and Sediment - Drain
Cooling System Coolant Level - Check
Driven Equipment - Inspect/Replace/Lubricate
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Walk-Around Inspection
Initial 250 Service Hours (or at first oil change)
Engine Valve Lash - Inspect/Adjust
Every 250 Service Hours
Cooling System Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Drive Shaft Universal Joints - Lubricate
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Power End Oil and Filter - Change
Every 1000 Service Hours
Cooling System Coolant Sample (Level 2) - Obtain
Engine Crankcase Breather - Clean
Engine Protective Devices - Check
Every 2000 Service Hours
Crankshaft Vibration Damper - Inspect
Driven Equipment - Check
Engine Mounts - Check
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Inspect/Adjust
Turbocharger - Inspect
Every 3000 Service Hours or 3 Years
Cooling System Coolant (DEAC) - Change
Cooling System Coolant Extender (ELC) - Add
Every 4000 Service Hours
Overhaul Considerations
Every 6000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
Cooling System Water Temperature Regulator - Replace
Water Pump - Inspect
Every 8000 Service Hours
Overhaul Considerations