SEAL KIT- 1857680 - Caterpillar

Gas under pressure. Rapid discharge from disconnecting or disassembly could cause personal injury or death. See service manual before relieving pressure or charging.
Fall Hazard (6)This safety message is located on the main beam between the rocker pads and on the rear of each fender near the rocker pads.
g01370910
Do not use this surface as a step or platform. This surface may not support additional weight or may be slippery. Serious injury or death could occur from a fall.
Crushing Hazard (7)This safety message is located on each of the four suspension cylinders.
g01370911
HIGH PRESSURE CYLINDERDo not remove any valve, hydraulic fitting, or valve core, nor disassemble any parts until pressure has been relieved.To relieve pressure, truck frame must be properly supported. Failure to comply with this warning will cause unexpected machine movement resulting in serious injury or death.Refer to your Service Manual for correct procedures for relieving pressure and/or correct charging procedures.See your Caterpillar dealer who has tools and detailed information for servicing and charging cylinders.
For information on servicing the suspension cylinders, refer to Systems Operation, Testing and Adjusting, RENR8270.High Pressure Cylinder (8)This safety message is located on each of the four suspension cylinders.
g01370912
Hydraulic accumulator contains gas and oil under high pressure. Improper removal or repair procedures could cause severe injury. To remove or repair, instructions in the service manual must be followed. Special equipment is required for testing and charging.
For information on servicing the suspension cylinders, refer to Systems Operation, Testing and Adjusting, RENR8270.Body Up Pin (9)This safety message is located on the rear of the dump body near the points that are used to retain the body in the UP position.
g01955512
A raised body (bed) may fall unexpectedly and without warning resulting in personal injury or death.When it is necessary to work under the truck with the body (bed) raised, install the body (bed) retaining pins through the pin bores in the frame and the retaining brackets on the body.
For information on the installation and removal of the body retaining pins, refer to Operation and Maintenance Manual, "Body Retaining Pin".Hot Coolant Under Pressure (10)This safety message is located on the radiator cap.
g01370913
The coolant is hot and the coolant is under pressure. Do not touch the hot surfaces. Refer to the Operation and Maintenance Manual for the procedure to follow when you check the radiator.
Product Link (11) (If Equipped)If the machine is equipped with Product Link, this safety message is inside the cab in an area that is visible to the operator.
g01370917
This machine is equipped with a Caterpillar Product Link communication device. When electric/electronic detonators are used, this communication device should be deactivated within 12 m (40 ft) of a blast site, or within the distance mandated under applicable legal requirements. Failure to do so could cause interference with blasting operations and result in serious injury or death.