SEAL KIT- 1864333 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 439-3940 Link Bracket 2 Start By:
Remove the turbocharger.
Remove the electronic control module.
Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand.Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns.Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes.
Note: Put identification marks on all lines, on all hoses, on all wires and on all tubes for installation purposes. Plug all lines, all hoses, and all tubes. This will help to prevent fluid loss and will help to keep contaminants from entering the system.
Drain the coolant from the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Illustration 1 g03831086
Disconnect harness assemblies (1) and (3).
Disconnect tube assembly (2) and hose assembly (5) from the exhaust manifold.
Remove bolts (4) and harness housing assembly (6).
Illustration 2 g03831097
Attach Tooling (A) and a suitable lifting device to exhaust manifold (8). The weight of exhaust manifold (8) is approximately 37 kg (82 lb).
Remove bolts (7), exhaust manifold (8), and the gaskets.