SEAL GP 1882103 - Caterpillar

Table 1
Required Tools    
Part Number    Description    Qty    
5P-3277     Measuring Tape     1    
    Stopwatch     1    
Illustration 1 g00924510
(A) Preliminary run 5 m (16.4 ft) (B) Travel distance 20 m (65.6 ft) (C) Height of grapple 0.5 to 1 m (1.6 to 3.3 ft)
Travel distance must be at least 25 m (82 ft) long. Travel test ground must be hard and as level as possible.
Draw a 25 m (82 ft) straight line on travel test ground as a reference line.
Start the engine.
Place the machine controls at the following settings: Engine speed dial "10" and AEC switch OFF.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Position the machine so that one track is parallel with the reference line. Position the machine for the travel test. Refer to Illustration 1.
Place the travel speed control switch in HIGH position.
Move the machine by operating both travel levers at the same time.
The first 5 m (16.4 ft) are for a preliminary run. Measure the travel time that is required to travel the remaining 20 m (65.6 ft). Measure the time that is required in each direction.
Measure the travel deviation from the reference line.
Place the travel speed control switch on the LOW position and repeat Steps 8 through 10.
Table 2
Travel Time (time in seconds)    
Travel Speed    New    Rebuild    
HIGH     Forward     15.2 or less     16.2 or less    
Reverse
LOW     Forward     24.0 or less     25.5 or less    
Reverse Note: The following table represents the travel deviation (distance) from the reference line.
Table 3
Travel Deviation
mm (inch)    
Travel Speed    New    Rebuild    Service Limit    
HIGH     Forward     800 (31.5) or less     1200 (47.2) or less     1500 (59.1) or less    
Reverse
LOW     Forward     800 (31.5) or less     1200 (47.2) or less     1500 (59.1) or less    
Reverse