SEAL-KIT 1884457 - Caterpillar

Illustration 1 g00537644
Illustration 2 g01146819
Charging dimensions for a suspension cylinder which has been purged Charge with oil ... 25.4 mm (1.00 inch) Full charge of oil and nitrogen ... 170.0 mm (6.69 inch)Note: Use FT1680 Gauge Block in order to achieve the dimension for the full charge of oil and nitrogen. See Testing and Adjusting, "Suspension Cylinder (Front) - Purge and Charge" for the charging procedure. (1) Torque for the two nuts ... 945 35 N m (697 26 lb ft) (2) Torque for the 12 nuts ... 945 35 N m (697 26 lb ft) (3) 7D-2878 Shim ... 4.47 0.08 mm (0.176 0.003 inch)Note: See the steering system Testing and Adjusting, "Front Axle - Install and Adjust" in order to determine the thickness that should be installed.
Personal injury or death can result when working with the strut rod.Sudden release of the spindle from the strut rod or the snapping of a bolt when removing the plate can result in injury.Loosen all bolts one-half turn, working around the plate in a circular pattern. Perform this again and again until the torque is released for the bolts.
(4) Final torque for ten bolts ... 1085 35 N m (800 26 lb ft)Note: Perform the steering system Testing and Adjusting, "Front Axle - Install and Adjust" before you install these bolts. (5) Torques for 30 bolts Static inspection torque for 30 bolts ... 60 N m (44 lb ft) Assembly torque for 30 bolts ... 135 20 N m (100 15 lb ft) (6) 238-9928 Charging valve assembly Installation torque for the valve ... 14 1 N m (10.3 0.7 lb ft) Closure torque for the valve ... 7 1 N m (62 9 lb in) Torque for the valve cap ... 2.5 0.5 N m (22 4 lb in) (7) Apply 8T-9014 Silicon Sealant prior to assembly. (8) Torque for the ten bolts ... 135 20 N m (100 15 lb ft) (9) Outside diameter of piston (two lands) ... 201.17 0.13 mm (7.920 0.005 inch) (10) Inside diameter of the tube ... 203.25 + 0.13 - 0.05 mm (8.002 + 0.005 - 0.002 inch) (11) Inside diameter of gland (three places) ... 178.18 0.03 mm (7.015 0.001 inch) (12) Outside diameter of rod ... 177.72 0.05 mm (6.997 0.002 inch) (13) Fill the lower cavity with 7X-7664 Grease after assembly. (14) Apply a coat of 4C-5593 Anti-Seize Compound before assembly with spindle.Note: Approximately 12.8 L (3.38 US gal) of SAE 10W oil with the current service classification is necessary in order to charge a cylinder.Note: If the front suspension cylinder is disassembled, reassemble the cylinder only in the vertical position.The charging medium for suspension cylinder is dry nitrogen.Internal volume ... 5.33 L (325 in3)Charged pressure ... 1600 kPa (230 psi)Service pressure ... 4500 kPa (650 psi)Bursting pressure ... 35000 kPa (5075 psi)Charged safety factor