SEAL 1913040 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
B     1U-6684     Piston Ring Compressor     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Thoroughly clean all of the components.
Lubricate the piston and the cylinder bore with clean engine oil.
Rotate the crankshaft until the connecting rod journal is at the bottom center position. Lubricate the connecting rod journal with clean engine oil.
Install the upper connecting rod bearing cap in the connecting rod. Ensure that the locating tab is correctly installed in the connecting rod.
Lubricate the bearing for the upper connecting rod journal with clean engine oil.
Align the piston rings on the piston so that the distance between the gaps is 120 degrees.
Illustration 1 g01224228
Install Tooling (B) on the piston in order to compress the piston rings prior to installation.Note: Ensure that Tooling (B) is installed correctly and that the piston can easily slide out of the Tooling.Note: The arrow or the "FRONT" Mark that is on the top of the piston must be toward the front of the engine.
Push the piston and the connecting rod assembly slowly into the cylinder liner and onto the connecting rod journal. Ensure that the connecting rod does not contact the cylinder bore or the connecting rod journal on the crankshaft.
Install the lower connecting rod bearing in the connecting rod cap. Ensure that the locating tab is correctly installed in the connecting rod cap.
Lubricate the lower connecting rod bearing with clean engine oil.
Illustration 2 g00550548
Install connecting rod caps (2) with the bolts and nuts (1) .
Use the following procedure with serrated connecting rods and flat connecting rods:
If the connecting rod cap is held in position with bolts and nuts, tighten the nuts to a torque of 125 N m (92 lb ft).
If the connecting rod cap is held in position with bolts, tighten the bolts to a torque of 155 N m (114 lb ft).
Use the following procedure with hydraulically fractured connecting rods:Note: Do not reuse the bolts. New bolts should be used.
Tighten the bolts to a torque of 70 N m (52 lb ft).
Tighten the bolts for an additional 120 degrees.
Rotate the crankshaft in order to ensure that there is no binding.
Refer to the Testing and Adjusting, "Connecting Rod - Inspect" for the correct procedure on checking the length of a connecting rod.End By:
Install the piston cooling jets. Refer to Disassembly and Assembly, "Piston Cooling Jets - Remove and Install".
Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".
Install the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Install".