SEAL-O-RING 1920626 - Caterpillar

"Idle Shutdown Time"The "Idle Shutdown Time" is the time (minutes) of engine idle before shutting down. The engine will only shut down if the ECM senses low engine load and no vehicle speed. The "Idle Shutdown Time" will not begin counting if the engine is in Cold Mode. If this parameter is programmed to zero, this feature is disabled and the engine will idle until the keyswitch for the ignition is in the OFF position.Note: This feature does not shut down the vehicle's power. The ECM and the vehicle remain powered.
Table 1
Minimum     Maximum     Default    
3 minutes     1440 minutes     0 minutes    "Allow Idle Shutdown Override"This parameter determines if the clutch or the service brake can be used to override the idle shutdown timer during the driver alert. The driver alert is the last 90 seconds when the check engine lamp begins flashing. This parameter requires the "Idle Shutdown Time" to be programmed to a 3 or more minutes for the parameter to be enabled. When the "Idle Shutdown Time" is programmed to 0, the parameter is turned off.
Table 2
Alternative     Default    
"NO"     "YES"    "A/C Switch Fan-On Time"Input 11 to the ECM can be used for the connection of a normally closed high pressure A/C switch. The ECM has a built-in timer. The timer is used to prevent excessive cycling of the cooling fan clutch due to successive cycling of the A/C switch. Programming this parameter to 0 disables the function. Programming depends on the refrigerant, and the design of the air conditioning system as well as the use of the signal input. Program the timer to 1 second for the connection of this input to another system. Programming the timer to 1 second also provides a time delay. This feature requires the "Fan Control Type" parameter to be programmed to "On/Off" or to "Variable Speed Fan Option S". Also, the "A/C High Pressure Switch" parameter must be programmed to "J1/P1:41"or to "J1/P1:62" for GMT-560.
Table 3
Manufacturer     Minimum     Maximum     Default    
GM     N/A     N/A     N/A    
Other     0 seconds     600 seconds     0 seconds    OCT01 and newer Personality Modules.
Table 4
Minimum     Maximum     Default    
0 second     600 seconds     0 seconds    "Fan with Engine Brake On"This parameter determines whether the cooling fan will turn on when the engine brake has been active for at least two seconds. This feature requires the "Fan Control Type" parameter to be programmed to "On/Off". An on/off fan must also be installed in order for this option to be functional.
Table 5
Manufacturer     Alternatives     Default    
GM     N/A     N/A    
Other     "YES"     "NO"    OCT01 and newer Personality Modules.
Table 6
Alternatives     Default    
"YES"     "NO"    "Exhaust Brake Configuration"OCT01 and newer Personality Modules.This parameter determines the functionality of the exhaust brake. The exhaust brake