1932693 SEAL Caterpillar parts
318C, 319C, 320C, 320C FM, 325C
Rating:
Alternative (cross code) number:
CA1932693
193-2693
1932693
CA1932693
193-2693
1932693
Weight: 0.06 pounds 0 kg.
EXCAVATOR,
Number on catalog scheme:
7
For full view, you need register
Information:
Illustration 1 g01269345
Circle Right Solenoid connections
This diagnostic code is associated with the circle right solenoid. The FMI 06 means that the Implement ECM 2 has determined that the current of the solenoid circuit is above normal. The Implement ECM 2 communicates this condition to the Implement ECM over the J1939 data link and the Implement ECM will activate this diagnostic code.The Implement ECM 2 provides a PWM output signal to the solenoid in order to provide proportional control of the solenoid. The ECM will vary the electrical current of the PWM output signal based on the input command that is received from the circle drive position sensor that is located in the right joystick assembly.Some possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is shorted to ground.
The solenoid has failed.
The ECM has failed. This is unlikely. Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Note: The resistance of the solenoid coil should be 8.7 .4 ohms at 25 °C (77.0 °F).Test Step 1. CHECK THE SOLENOID
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness. Expected Result:The active CID 2168 FMI 06 diagnostic code changes to a CID 2168 FMI 05 diagnostic code when the solenoid is disconnected.Results:
YES - The active CID 2168 FMI 06 diagnostic code changes to a CID 2168 FMI 05 diagnostic code when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid.STOP
NO - The CID 2168 FMI 06 remains active when the solenoid is disconnected. The solenoid is not causing the problem. Proceed
Caterpillar parts catalog:
Parts seal Caterpillar catalog:
318C, 319C, 320C, 320C FM, 330C, 330C FM, 330C L, 330C MH
318C, 319C, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 321C, 321D LCR, 323D L, 323D LN, 323D SA
2597319
SEAL
308D, 314C, 314D LCR, 321C, 321D LCR, 328D LCR
308D, 314C, 314D LCR, 321C, 321D LCR, 328D LCR
2597318
SEAL
308D, 314C, 314D LCR, 321C, 321D LCR, 328D LCR
308D, 314C, 314D LCR, 321C, 321D LCR, 328D LCR
2070095
SEAL-O-RING
314C, 321C
314C, 321C
2070094
SEAL-O-RING
314C, 321C
314C, 321C
1636759
SEAL
307D, 308D, 311D LRR, 311F LRR, 312C, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314D CR, 314D LCR, 314E CR, 314E LCR, 315C, 315D L, 316E L, 318C, 318D L, 318D2 L, 3...
307D, 308D, 311D LRR, 311F LRR, 312C, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314D CR, 314D LCR, 314E CR, 314E LCR, 315C, 315D L, 316E L, 318C, 318D L, 318D2 L, 3...
312, 318C, 319C, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 321C, 321D LCR, 323D L, 323D LN, 323D SA
1352355
SEAL-O-RING
311, 318C, 319C, 320B, 320B U, 320C, 320C FM, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320N, 321C, 321D LCR, 323D L, 323D LN, 323D SA
311, 318C, 319C, 320B, 320B U, 320C, 320C FM, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320N, 321C, 321D LCR, 323D L, 323D LN, 323D SA
1932769
SEAL
318C, 319C, 320C, 320C FM
318C, 319C, 320C, 320C FM
1968200
SEAL
314D CR, 314D LCR, 318C, 319C, 320C, 320C FM
314D CR, 314D LCR, 318C, 319C, 320C, 320C FM
311D LRR, 312D, 312D L, 318C, 319C, 320C, 320C FM