1948334 SEAL-LIP TYPE Caterpillar parts
320C FM, 322C FM, 325C FM, 330C FM
Rating:
Alternative (cross code) number:
CA1948334
194-8334
1948334
CA1948334
194-8334
1948334
Weight: 0.03 pounds 0 kg.
EXCAVATOR,
Number on catalog scheme:
19
For full view, you need register
Information:
Illustration 1 g00562901
Schematic of the diverter solenoid (brake oil) This diagnostic code is associated with the diverter solenoid (brake oil). The FMI 06 means that the ECM has determined that the current of the solenoid is above normal. The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is shorted to ground.
The solenoid has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1231 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness. Expected Result:CID 1231 FMI 06 changes to CID 1231 FMI 05 when the solenoid is disconnected.Results:
YES - CID 1231 FMI 06 changes to CID 1231 FMI 05 when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Stop.
NO - CID 1231 FMI 06 remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO GROUND.
Turn the key start switch and the disconnect switch to the OFF position.
The solenoid remains disconnected from the machine harness.
Disconnect the machine harness connector(s) from the ECM.
At the machine harness connector, measure the resistance from the signal contact J2-55 (wire 987-WH) to all contacts that are used in the machine harness connectors for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J2-55 (wire 987-WH) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness. Stop.Test Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the harness connectors and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 1231 FMI 06. Expected Result:The CID 1231 FMI 06 is active. Results:
YES - The CID 1231 FMI 06 is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace". Stop.
NO - The CID 1231 FMI 06 is not active. The diagnostic code does not exist at this time.
Caterpillar parts catalog:
Parts seal Caterpillar catalog:
120H, 135H, 3126, 3126B, 3126E, 322C, 322C FM, 325C, 325C FM, 3406E, 3456, 385B, 5090B, 561N, 570B, 580B, 938G II, 950G II, 953C, 962G II, 963C, 980G II, C-10, C-12, C7, D350E II, D400E II, D5N, D6N, ...
320B, 320B FM LL, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 321C, 321D LCR, 322...
320C, 320C FM, 320D, 320D FM, 320D FM RR, 322C, 322C FM, 323D LN, 323D SA, 323E L, 324D, 324D L, 324D LN, 324E, 324E L, 324E LN, 325C, 325C FM, 325D, 325D L, 325D MH, 326D L, 329D, 329D L, 329D LN, 32...
320C, 320C FM, 320D, 320D FM, 320D FM RR, 322C FM, 323D LN, 323D SA, 323E L, 324D FM, 324D FM LL, 325C, 325D, 325D L, 329D, 329D L, 329D LN, 329E, 329E L, 329E LN, OEMS
320C, 320C FM, 320D, 320D FM, 320D FM RR, 322C FM, 323D SA, 323E L, 324D FM, 324D FM LL, 325C, 325D, 325D L, 329D, 329D L, 329D LN, 329E, 329E L, 329E LN, OEMS
320C, 322C, 322C FM, 323D LN, 323D SA, 323E L, 324D FM, 324D FM LL, 325B L, 325C, 325C FM, 325C L, 325D, 325D L, 325D MH, 329D, 329D L, 329D LN, 329E, 329E L, 329E LN, 330C, 330C L, 330D, 330D L, 336D...
320C, 322C, 322C FM, 323D LN, 323D SA, 323E L, 324D FM, 324D FM LL, 325B L, 325C, 325C FM, 325C L, 325D, 325D L, 325D MH, 329D, 329D L, 329D LN, 329E, 329E L, 329E LN, 330C, 330C L, 330D, 330D L, 336D...
320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LRR, 320D RR, 323D L, 323D LN
320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 L, 321C, 321D LCR, 322C, 323D L, 323D LN, 323D SA, 323D2 L, 324D, 324D L, 325C, 325D, 325D L...
322C, 322C FM, 324D FM, 324D FM LL, 325C, 325C FM, 325D FM, 325D FM LL, 325D L, 325D MH, 328D LCR, 329D L, 330C, 330C L, 330D, 330D L, 330D LN, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336...
324D, 325C, 325D L, 328D LCR, 330C, 330C FM, 330C L, 330D, 330D FM, 330D L, 330D LN, 336D, 336D L, 340D L, 345C, 345C L, 345C MH, 385C L, W345C MH
324D, 325C, 325D L, 328D LCR, 330C, 330C FM, 330C L, 330D, 330D FM, 330D L, 330D LN, 336D, 336D L, 340D L, 385C L
1915683
SEAL-U-CUP
320C FM, 322C FM, 325C FM, 330C FM
320C FM, 322C FM, 325C FM, 330C FM
1948332
SEAL-LIP TYPE
320C FM, 322C FM, 325C FM, 330C FM
320C FM, 322C FM, 325C FM, 330C FM
1672473
SEAL-WIPER
322C, 322C FM, 325C L, 345B II
322C, 322C FM, 325C L, 345B II
1640513
SEAL
320C, 330C L
320C, 330C L
322C, 325D L, 329D, 329D L, 330C L, 330D L, 336D, 336D2, 340D L, 340D2 L
322C, 325D L, 329D, 329D L, 330C L, 330D L, 336D, 336D2, 340D L, 340D2 L
1741381
SEAL
554, 564, 574B
554, 564, 574B
2183140
SEAL
554, 564, 574B
554, 564, 574B
322C, 322C FM, 324D FM, 324D FM LL, 325C, 325C FM, 325D FM, 325D FM LL, 325D L, 325D MH, 328D LCR, 329D L, 330C, 330C L, 330D, 330D L, 330D LN, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336...
2522151
SEAL
320C, 322C, 325C, 330C, 330C L
320C, 322C, 325C, 330C, 330C L
2138401
SEAL-LIP TYPE
M322C, M322D, M322D MH
M322C, M322D, M322D MH
2942009
SEAL
M322C, M322D, M322D MH
M322C, M322D, M322D MH