1948363 SEAL KIT Caterpillar parts
325C L
Rating:
Alternative (cross code) number:
CA1948363
194-8363
1948363
CA1948363
194-8363
1948363
Weight: 0.70 pounds 0 kg.
EXCAVATOR,
Compatible equipment models: 1948363:
Number on catalog scheme:
None
For full view, you need register
Information:
Illustration 1 g02139336
The Swing Brake Solenoid is located on the underside of the cab and behind the swing bearing.
Illustration 2 g02030393
Schematic of the "Swing Brake" solenoid
This diagnostic code is associated with the "Swing Brake" solenoid. The FMI 06 diagnostic code means that the Machine ECM has determined that there is a short to ground in the circuit. The possible causes of this diagnostic code are listed below:
The energize circuit of the solenoid is shorted to ground.
The solenoid has failed.
The Machine ECM has failed. A failure of the ECM is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0374 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK THE SOLENOID
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness. Expected Result:The CID 0374 FMI 06 diagnostic code changes to a CID 0374 FMI 05 diagnostic code when the solenoid is disconnected.Results:
YES - The CID 0374 FMI 06 diagnostic code changes to a CID 0374 FMI 05 diagnostic code when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid.STOP
NO - The CID 0374 FMI 06 diagnostic code remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO GROUND
Turn the key start switch and the disconnect switch to the OFF position.
The solenoid remains disconnected from the machine harness.
Disconnect the machine harness connectors from the Machine ECM.
At the machine harness connector, measure the resistance from the signal contact J1-3 (wire K906-GN(Green)) to all contacts that are used in the machine harness connectors for the Machine ECM. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between J1-3 (wire K906-GN(Green)) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness. STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the harness connectors. Clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0374 FMI 06 diagnostic code. Expected Result:The CID 0374 FMI 06 diagnostic code is active. Results:
YES - The CID 0374 FMI 06 diagnostic code is active. The diagnostic code has not been corrected. The Machine ECM may have failed.Repair: A failure of the Machine ECM is unlikely. Exit this
Caterpillar parts catalog:
Parts seal Caterpillar catalog:
120G, 12G, 12M, 130G, 140M, 14E, 14G, 153, 16, 160M, 163, 1693, 16G, 173B, 183B, 215, 215B, 215C, 215D, 219D, 225, 225D, 227, 229, 229D, 231D, 235, 235B, 235C, 235D, 245, 245B, 312B L, 315B L, 317B LN...
305.5D, 305.5E, 305C CR, 307, 307B, 307C, 308C, 308D, 311, 311B, 311C, 311D LRR, 312, 312B, 312B L, 312C, 312C L, 312D, 312D L, 312E, 312E L, 313B, 313D, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 32...
1090, 1190, 1190T, 1290T, 1390, 2290, 2384C, 2390, 2391, 2484C, 2491, 2590, 303, 303.5, 303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304D CR, 304E, 307C, 307D, 308C, 308D, 308E, 308E CR, 308E SR, 311, 31...
1190T, 1290T, 1390, 231D, 2391, 2491, 2590, 315, 315B, 315B L, 315C, 315D L, 317, 317B LN, 318B, 318C, 319C, 319D, 319D L, 319D LN, 320, 320 L, 320B, 320B FM LL, 320B L, 320B U, 320C, 320C FM, 320D, 3...
308D, 308E, 308E2 CR, 311C, 312C, 312C L, 314C, 320C, 320D, 322C, 323D L, 324D, 324D L, 325C, 325C L, 325D, 325D L, 329D L, 330C, 330C L, 525C, 535C, M312, M313C, M313D, M315D 2, M317D 2
303, 303.5, 303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304, 304.5, 304C CR, 304D CR, 304E, 305, 305.5D, 305.5E, 305C CR, 305D CR, 305E, 307, 307B, 307C, 307D, 307E, 308C, 308D, 308E, 308E CR, 308E SR, ...
304, 307, 307B, 307C, 307D, 308C, 308D, 311C, 312C L, 314C, 315C, 318C, 319C, 320C, 320C FM, 321C, 322C, 322C FM, 323D L, 323D LN, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 325C, 325C FM, 325C L, 32...
307C, 320C, 322B LN, 322C, 322C FM, 324D, 324D FM, 324D L, 324D LN, 324E, 324E L, 324E LN, 325C, 325C FM, 325C L, 325D, 325D FM, 325D L, 326D L, 328D LCR, 329D, 329D L, 329D LN, 329E, 329E L, 329E LN,...
311C, 311D LRR, 311F LRR, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 320C, 320D, 320D L, 320D2, 320D2 L, 320E, 32...
320B, 320C, 322B, 322B L, 322B LN, 322C, 322C FM, 323D L, 324D, 324D L, 324D LN, 325B, 325B L, 325C, 325C FM, 325C L, 325D, 325D FM, 325D FM LL, 325D L, 328D LCR, 329D, 329D L, 330B, 330B L, 330C, 330...
320 L, 320B, 320B FM LL, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 320N, 321C, ...
320B, 320B L, 320C, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 322C, 323D L, 323D LN, 323D SA, 324D, 324D L, 325C L
2083681
SEAL O-RING
345B L
345B L
330B, 330B L
0951371
SEAL
350 L
350 L
5300P219
SEAL
325B L
325B L
218P40066
SEAL
325B L
325B L
325B L
2251783
SEAL KIT
330C L
330C L
5G3144
SEAL
330C L
330C L
375
1729733
SEAL
375
375
2043697
SEAL KIT
325C L
325C L
1948366
SEAL KIT
325C L
325C L