SEAL-O-RING 1953443 - Caterpillar

Illustration 1 g01342344
Input/Output Cabinet - Left View (1) Left Component Panel (2) Ground (3) Output Breaker K5 (Optional) (4) Input Breaker K1There are seven copper input cable landings in the Input/Output Cabinet. Each of the cable landings have a tin coating. There is one landing for each phase of the three-phase input utility power. There is one landing for each phase of the three-phase output power. There is one landing for the ground. Refer to Illustration 1 for cable landing locations.The input cable landings are designed to accommodate 500 kcmil cable to 750 kcmil cable.The installer will punch the appropriate hole pattern for trade size conduit depending on the size and number of input cables.Cable Landing Phase Bar Removal
Perform steps in the Systems Operation, Testing and Adjusting, "Internal Component Preremoval Steps (Input/Output Cabinet)" in order to de-energize the system and gain access to internal components.
Disconnect the utility input cables from the cable landing.
Disconnect the wires that are connected to the back of the cable landing.
Remove the capacitor banks that are located at the back of the cable landing.Refer to Systems Operation, Testing and Adjusting, RENR7654, "Capacitor (Input/Output Cabinet)" for removal steps.
Loosen the back three bolts that connect the landing to the cabinet.
Loosen the front three bolts that connect the landing to the vertical bus bar leading into the circuit breaker.
Loosen the four bolts that connect the Maintenance Bypass output bus bars to the K5 cable landing.Note: Only for output cable landing removal with Maintenance Bypass Option installed.
Remove the cable landing.Cable Landing Phase Bar Installation
Place the cable landing in position.Refer to Illustration 1.
Attach the front landing to the vertical bus bar that extends from the top of the circuit breaker. Accomplish this task by inserting three bolts with the heads of the bolts toward the rear of the cabinet.
Illustration 2 g01271171
(20) Nut (21) Belleville Washer (22) Grade 8 Coated Steel Washer (23) Bus Bars (24) Bolt
Attach washers and nuts in the order indicated in Illustration 2.Note: In all cases, the side of the belleville washer that curves inward should be placed facing the bus bar.
Insert three bolts at the back of the cable landing.Place bolt and steel washer through the following components: the cable landing and a red insulating spacer Attach the bolts to the threaded huck rivets at the back of the cabinet.Note: Step 5 is for output cable landing installation with Maintenance Bypass Option.
Attach the vertical bus bars that extend from the Maintenance Bypass Cabinet to the output cable landing. Use four bolts through the right side of the bus bars.Note: Step 6 is for output cable landing installation with Maintenance Bypass Option.
Secure the bus bars via the attachment method that is shown in Illustration 2.
Attach the capacitor banks that are located at the back of the cable landing.Refer to Systems Operation, Testing and Adjusting, RENR7654, "Capacitor (Input/Output Cabinet)" for installation steps.
Attach the wires leading to the fuses and circuit breakers to the pegs at the back of the cable landing.
Table 1
Wire Color    Phase    
Brown     A