SEAL AS 1974727 - Caterpillar

System Operation Description:The "AUTO" mode is initiated by a Modbus RS-485 SCADA data link message or by pressing the "AUTO" key.Continuous activation of the remote initiate input causes the engine to start and to run if the following conditions exist:
A programmed start aid activation delay and crank alert interval have occurred
The engine is in auto mode
No shutdowns are activeWhen the remote initiate signal is removed, then the engine will cool down and then stop. When the generator set control is not in auto mode, a "GEN CONTROL NOT IN AUTO " will appear on the EMCP 3 display. The message is used to inform the operator of the "not in auto condition".Note: The event can be disabled via the "Generator Control Not in Automatic Warning Event Response Configuration" set point.The code is generated when the generator set control is not in auto mode.Test Step 1. Talk to the Operator.Note: The repair information in this section assumes that no repair to the engine is necessary.
Determine the conditions that caused the diagnostic code.Expected Result:The generator was place into a mode other than "AUTO" by the operator or by a Modbus RS-485 SCADA data link message .Results:
OK - STOP